This document discusses key concepts in transportation engineering related to traffic flow fundamentals, including:
1) It defines different types of traffic flow - uninterrupted flow which is not required to stop, and interrupted flow at intersections which may be required to stop.
2) It describes key traffic variables - flow rate, speed, density, and how they are calculated and related. Density is the most difficult variable to observe directly.
3) It provides examples of calculations involving these variables, including time mean speed, space mean speed, and using the variables to calculate flow rate.
Download as DOCX, PDF, TXT or read online on Scribd
50%(2)50% found this document useful (2 votes)
851 views
Traffic Flow
This document discusses key concepts in transportation engineering related to traffic flow fundamentals, including:
1) It defines different types of traffic flow - uninterrupted flow which is not required to stop, and interrupted flow at intersections which may be required to stop.
2) It describes key traffic variables - flow rate, speed, density, and how they are calculated and related. Density is the most difficult variable to observe directly.
3) It provides examples of calculations involving these variables, including time mean speed, space mean speed, and using the variables to calculate flow rate.
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3
PRINCIPLES OF TRANSPORTATION ENGINEERING (LECTURE)
TRAFFIC FLOW FUNDAMENTALS
A. TRAFFIC D. SPEED imagine the development of traffic along the rate of motion in distance per unit time. expressway. When describing traffic stream, two In the early morning, drivers can freely types of speed are used: choose their own speeds because there are o Time Mean Speed only very few vehicles on the road. spot speed, As traffic density increases, the drivers are constrained to adjust their speeds. the arithmetic mean of the speeds of Traffic condition becomes very unstable vehicles passing a point within a given when the capacity of the highway has already interval of time. been reached, after which a stop and go condition will be experienced if the situation worsens
B. TYPES OF FLOW
Flow occurring at long sections of road
where vehicles are not required to stop o Space Mean Speed by any cause external to the traffic used to describe the rate of movement stream is called uninterrupted flow of a traffic stream within a given o Uninterrupted flow can be described section of road. using any of the following major traffic speed based on the average travel time variables: of vehicles in the stream within the Flow rate or volume section. Speed also called the harmonic mean speed Density or concentration If n vehicles are observed at an instant On the other hand, flow occurring at of time t, the space mean speed is intersections or driveways where vehicles computed as follows: are required to stop by any cause outside the traffic stream - such as traffic signs (STOP or YIELD), traffic signal lights, etc. - is called interrupted flow
C. FLOW RATE OR VOLUME
Number of vehicles passing a point
during a specific period of time E. DENSITY Often referred to as volume when Number of vehicles in a given length measured over an hour. of a road at an instant point in time May be expressed as: If n vehicles are found within the N section L, density k is computed as: q= T n k= q=K μs L Among these variable, density proves intervals of 8 sec, 9 sec, 10 sec, 11 sec, to be the most difficult or expensive to and 13 sec. respectively. The speeds of observe. the vehicles were 80kph, 76kph, 70 kph, 60kph and 50 kph respectively. E.1 SAMPLE PROBLEMS a. Compute the time mean speed. 1) Let us suppose a 15-minute count of ui= ∑i vehicles bound for Manila was conducted n at a particular location on Quezon Avenue. A summary is shown in the 80+76+70+60+ 50 ui = = 67.2 kph table below 5 b. Compute the space mean speed if the distance travel by the vehicles is 250m Total number of vehicles: 420+300+16+28 = nd nd = u s= u s= 764 vehicles ∑t ∑t N 5(250) q= = 24.51 m/s T 8+9+10+11+13 c. If the density of traffic is 20 vehicles q=K μs = 764 x 4 = 3056 vehicles / hr per km, compute the rate of flow of traffic in vehicles/ hr. 2) Data on traffic passing thru an intersection indicates that vehicles moved 24.51 m/s x 3.6 = 88.24 kph at a space mean speed of 40 mph where the density is 22 vehicles per hour per q=K μs = 20 x 88.24 = 1764.8 vehicles / hr mile. Compute the rate of flow in 5) Two sets of students are collecting traffic vehicles per hour data at two sections A and B of a Density in vehicles/hour/mile (K) = 22 highway 200m apart. Observation at A space mean speed = 40 mph shows that 5 vehicles passes that section at intervals of 8.18s, 9.09s, 10.23s, q=K μs = 22 x 40 = 80 vehicles / hr 11.68s, and 13.64s respectively. If the speed of the vehicles were 80,72,64,56 3) The speed of 25 cars was observed. 10 and 48 kph respectively. cars were noted to travel at 35 kph, 8 cars a. Compute the density of traffic in at 40 kph, 2 cars at 50 kph, and 5 cars at vehicles per km 45 kph. Assuming that each car was traveling at constant speed, determine the n 5 1000 m time mean speed. K= = x = 25 L 200 m 1 km n vehicles/hr ∑ ¿ 1 ui b. Compute the time mean speed in kph i ui = n n
(10 x 35)(8 X 40)(2 X 50)(5 x 45)
∑ ¿ 1 ui ui = = ui = i 25 n 39.8 kph 80+72+64+56 +48 4) In an observation post shows that 5 ui = = 64 kph 5 vehicles passes through the post at c. Compute the space mean speed in kph nd nd = u s= u s= ∑t ∑t 5(200) 8.18+9.09+10.23+11.68+13.64 = 64.18 kph 6) From the data of a highway traffic observation team, shows the distances each vehicle have traveled every 3 secs. On a portion of the highway
a. Compute the density of traffic in
vehicles per km. n 4 1000 m K= = x = L 88+86+ 83+832 1 km 4720 vehicles / hr b. Compute the flow of traffic n q= t q=K μs = 4720 x 101.7 kph = 4800.24 vehicles/hr c. Compute the space mean speed in kph. nd nd = u s= u s= ∑t ∑t 88+86+ 83+82 = 28.25 m/s 4 (3) 28.25 m/s x 3.6 = 101.7 kph