Scribd
Upload
28 views3 pages

include-WPS Office

This document contains code to control four LEDs using an IR receiver and remote control keys. It defines pins for the receiver and LEDs, sets up the receiver to decode signals, and switches the LEDs on or off depending on which key is pressed.

Uploaded by

MENGA MENGA patrick
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
28 views3 pages

include-WPS Office

This document contains code to control four LEDs using an IR receiver and remote control keys. It defines pins for the receiver and LEDs, sets up the receiver to decode signals, and switches the LEDs on or off depending on which key is pressed.

Uploaded by

MENGA MENGA patrick
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

#include

#define first_key 48703

#define second_key 58359

#define third_key 539

#define fourth_key 25979

int receiver_pin = 8;

int first_led_pin = 7;

int second_led_pin = 6;

int third_led_pin = 5;

int fourth_led_pin = 4;

int led[] = {0,0,0,0};

IRrecv receiver(receiver_pin);

decode_results output;

void setup()

Serial.begin(9600);

receiver.enableIRIn();

pinMode(first_led_pin, OUTPUT);

pinMode(second_led_pin, OUTPUT);

pinMode(third_led_pin, OUTPUT);

pinMode(fourth_led_pin, OUTPUT);

}
void loop() {

if (receiver.decode(&output)) {

unsigned int value = output.value;

switch(value) {

case first_key:

if(led[1] == 1) {

digitalWrite(first_led_pin, LOW);

led[1] = 0;

} else {

digitalWrite(first_led_pin, HIGH);

led[1] = 1;

break;

case second_key:

if(led[2] == 1) {

digitalWrite(second_led_pin, LOW);

led[2] = 0;

} else {

digitalWrite(second_led_pin, HIGH);

led[2] = 1;

break;

case third_key:
if(led[3] == 1) {

digitalWrite(third_led_pin, LOW);

led[3] = 0;

} else {

digitalWrite(third_led_pin, HIGH);

led[3] = 1;

break;

case fourth_key:

if(led[4] == 1) {

digitalWrite(fourth_led_pin, LOW);

led[4] = 0;

} else {

digitalWrite(fourth_led_pin, HIGH);

led[4] = 1;

break;

Serial.println(value);

receiver.resume();

You might also like