SPEC NO：QAHGC008
DATE：MAR.25.2011
FOR APPROVAL
SPECIFICATION OF HERMETIC COMPRESSOR
MODEL NO. K2-C340GETE-H
Attached Accessories
1.Refrigerant Oil Charged
2.Electrical Components
Motor protector 1 pce/set
Terminal cover 1 pce/set
Packing 1 pce/set
Packing 1 pce/set
Holder 1 pce/set
Flange nut 1 pce/set
3.Mounting components
Rubber mount 3 pcs/set
CUSTOMER
APPROVAL
THE SPECIFICATION FOR K2-C340GETE-H COMPRESSOR
General specification TCSM 002
1.Application
Evaporating temp. range
Refrigerant R22 (CHClF2) 1.4Kg Max.
2.Compressor data
Outline dwg. DA100D101
Design Rolling piston type rotary
Displacement 34.0 cc/rev.
Number of cylinder 1
Oil charge 4GSD 400 cc
Weight 17.2 kgws.
3.Performance
Performance curve TCC201
Refrigerating capacity
Current
Motor input
Notes:Conditions
Evaporating temp.
Condensing temp.
Return gas temp.
Ambient temp.
Liquid temp.
4.Motor data
Wiring diagram DA200D002
Motor type Permanent split capacitor
Output 2000 W
Rated voltage 208/230 V
Rated frequency 60 Hz
Phase Single
Locked rotor current
Insulation class E
5.Electrical components
Motor protector T0580/46 DA205D035 (08)
or B410-155-141E DA205D041 (05)
6.Terminal parts accessories
Terminal part assy DA400D041
Terminal cover 1 pce. DA405Q001
Protector holder 1 pce. DA406D035
Packing 1 pce. DA408D043
Packing 1 pce. DA408D031
Flange nut 1 pce. DA904D025
7.Mounting accessories
Compr. mounting DA300D003
Rubber mount 3 pcs. DA306D011
8.Optional parts
Nameplate 1 pce. DA912D045
TCSC183 Rev.04
K1、K2系列压缩机使用基准与界限
K1，K2 series rotary compressor application limitations
项目 标准条件 过载条件 备 注
No. Item Remarks
Standard condition Overload Condition
使用冷媒
1 R22(使用冷媒质量,适用JIS K1519规范)
Refrigerant
2 蒸发温度范围 -10～+15℃ -20℃以上
Evaporating 2
(2.61～7.05kg/cm G) (1.5kg/cm2G MIN)
3 +28～+65℃ +68℃以下 压缩机设计压力30kg/cm2G
凝缩温度范围
The design pressure for our compressor is
Condensing
2 2
(10.5～26.51kg/cm G) (28kg/cm G MAX) 30kg/cm2G
压缩比 6以下 8以下
4
Compressing ratio 6MAX 8MAX
马达线圈温度
100℃以下 125℃以下
5 Motor coil
100℃MAX 125℃MAX
temperature
压缩机底壳温度 100℃以下
6
Comp.bottom temp. 100℃MAX
排出气体温度 100℃以下 115℃以下 排放管量测
7
Dis.gas temp. 100℃MAX 115℃MAX measured at dis. pipe
吸入气体温度 吸入气体过热度+2℃以上 不可发生吸入液体之回流
8
Suc.gas temp. Superheat must be over +2℃ No liquid-back
供应电压 额定电压±10%以内 压缩机端子电压
9
Voltage range Rated voltage ±10% measured at comp. terminal
供应频率 额定频率±2%以内
10
Frequency range Rated frequency ±2%
ON-OFF频率 每循环3分钟以上运转，3分钟以上停止
11
ON-OFF Cycle 3 min-ON ，3 min-OFF/cycle at least.
冷冻油/冷媒之重量比,需保持在0.4以上。
液态充填冷媒，当系统有泄漏时，需完全排放后重新充填。 冷冻油密度：0.877g/cm3
冷媒充填
12 The weight ratio of oil to refrigerant must be over 0.4. The density of the oil charged is
Refrigerant charging
The refrigerant must be charged in liguid state.No additional 0.877g/cm3.
charge before total discharge while system leaks.
最低起动电压 1.0.8E,额定电压0.8倍. Rated voltage*0.8.
13 Minimum starting 2.环境温度20～35℃. Ambient temp. 20～35℃.
voltage 3.高/低压力平衡. Balanced pressure.
稳定运转时，油面需高于汽缸下缘5mm.
压缩机内油面
14 At steady state, oil level must be 5mm above the bottom of
Oil level
cylinder.
异常压力上升Abnormal 40 Kg/mm2G以下 冷却风扇停止时
15
pressure raising 40 Kg/mm2G MAX Fan-block condition
起动、停止及运输时：3.0 Kg/mm2G以下
16 配管应力(铜管) starting,stopping and transportation：3.0 Kgf/mm2G MAX.
Allowable stress of
tube (Copper tube) 运转时：2.0 Kg/mm2 G以下
operating：2.0 Kgf/mm2G MAX.
水分 系统中的水分需在100mg以下
17
Residual moisture 100 mg MAX.
真空度 系统真空度需在0.35mmHg以下
18
Vacuum Pressure The vacuum pressure in system must be less than 0.35mmHg.
倾斜 安装于系统时，压缩机的倾斜度需在5°以内
19
Tilt in operating The compressor incline angle must be less than 5°.
橡皮塞需从排放管侧先拔除，
橡皮塞拔除 橡皮塞拔除后压缩机需于10分钟内安装于系统 避免冷冻油喷出以及水分、杂质入侵
20
Rubber remove The compressor should be installed in 10 minutes after rubber Avoid the oil loss and foreign body in.
removed.
压缩机需储存于室内，避免日晒雨淋，环境温度-10～+65℃
储存
21 The compressor should be indoor storage and the ambient
Storage
temperature is between -10 to +65℃ to avoid poor climate.
TCSM002 REV.03
K2-C340GE 性能曲线
8.3 deg.liquid subcooled
1 φ 208V 60Hz
凝缩温度(℃)
15
60
12
50
电流(A)
9 40
6
3000
60
2400
50
入力(W)
1800 40
1200
600
10800 40
9000 50
冷冻能力(W)
60
7200
5400
3600
1800
0
-10 -5 0 5 10 15
蒸发温度(℃)
TCC201 1/2 REV.01
K2-C340GE 性能曲线
8.3 deg.liquid subcooled
1 φ 230V 60Hz
凝缩温度(℃)
12
60
50
9
40
电流(A)
3000
60
2400
50
入力(W)
1800 40
1200
600
10800 40
9000 50
冷冻能力(W)
60
7200
5400
3600
1800
0
-10 -5 0 5 10 15
蒸发温度(℃)
TCC201 2/2 REV.01
