Click or Tap Here To Enter Text. Click or Tap Here To Enter Text
Click or Tap Here To Enter Text. Click or Tap Here To Enter Text
General Physics 2
Module No.: 7
I. Topic: R-C CIRCUITS
II. Learning Targets:
At the end of the lesson, I can:
1. solve problems involving the calculation of currents and potential difference in circuits
consisting of batteries, resistors and capacitors;
2. identify the current and potential difference in charging or discharging the capacitor;
III. Introduction/Content/Review
RC circuit or Resistor-Capacitor circuit is a circuit with both resistor and capacitor. These are
frequent elements in electronic devices and it plays an important role in the transmission of electrical
signals in nerve cells.
In an R-C circuit, the capacitor does the storing of energy and the resistor placed in series with it will
control the rate at which it charges or discharges. This causes and produces a characteristic time
dependence that turns out to be exponential called the time constant or RC (τ). Note that 1 ohm
times 1 farad is equal to 1 second (1 𝛀) x (1F)= 1 sec.
The charge on capacitor cannot change instantaneously. Recall that current is equal to the change
∆𝑄
in charge over a change in time 𝐼 = ∆𝑡 . Hence, ∆𝑄 = 𝐼∆𝑡 and charge becomes zero as the time
interval 𝛥t goes to zero.
Example:
The natural response happens when you put some initial energy
into the circuit. If it is in an RC circuit, it represents charge that
is stored on the capacitor at the beginning of the analysis. The
image shown (figure 1) will explain what happens on the circuit
when the switch changed from a to b and is connected in a
battery to the RC combination and see what happens as the
capacitor discharges back through the resistor. The discharge
pattern is called the natural response. Let’s say that the switch has been in a for a very long time, the
current will flow out from the main source or battery (𝑉𝑏 ) going to the resistor and flow through the
capacitor leaving some charges in the capacitor (𝑉𝐶 ). As charge flowed to the capacitor, it piled up on
it and corresponding negative charge occurs (see figure 2).
1. Discharging of the capacitor = pot diff of capacitor decreases, because bottom plate of capacitor neutralizes
- The capacitor initially is connected (switch on position a) for a long time and is then
disconnected by moving the switch to b at time t=0. The capacitor then discharging,
leaving the capacitor without charge or voltage after a long time.
2. Charging the capacitor = pot diff of capacitor increases, because bottom plate of capacitor neutralizes
- The switch is on position b for a long time, allowing the capacitor to have a no chagre. At
time t=0, the switch is changed to a and the capacitor charges.
Discharging Charging
Charge 𝑄0 𝑒 −𝑡/𝑅𝐶 𝑄∞ (1 − 𝑒 −𝑡/𝑅𝐶
Current 𝐼0 𝑒 −𝑡/𝑅𝐶 𝐼∞ 𝑒 −𝑡/𝑅𝐶
Voltage 𝑉0 𝑒 −𝑡/𝑅𝐶 𝑉∞ (1 − 𝑒 −𝑡/𝑅𝐶 )
The 𝑄0 , 𝑉0 and 𝐼0 refers to the charge, voltage and current of the capacitors in the instant after the
switch is thrown.
The circuit has been in position a for a long time. At time t=0, the switch is thrown to position b. With
the following given 𝑉𝑏 = 12 V, 𝐶 = 10 𝜇𝐹, R= 20 Ω. Refer to the circuit below.
a.) What is the current through the resistor just before the switch is thrown?
b.) What is the current through the resistor just after the switch is thrown?
𝑉
Using Ohm’s law 𝐼 = 𝑅
12𝑉
𝐼=
20𝛺
𝑰= 0.6 A
c.) What is the charge across the capacitor just before the switch is thrown?
𝑄 = 𝐶𝑉
𝑄 = (10𝜇𝐹)(12𝑉)
𝑸 = 𝟏𝟐𝟎 𝝁𝑪 or 𝟏. 𝟐 𝒙 𝟏𝟎−𝟒 𝑪
d.) What is the charge on the capacitor just after the switch is thrown?
e.) What is the charge on the capacitor at a time t=0.3 msec after the switch is thrown?
−𝑡/𝑅𝐶
𝑄 = 𝑄0
𝑅𝐶 = (20 𝛺)(0.00001 𝐹)
𝑅𝐶 = 0.0002 𝑠𝑒𝑐 or RC=0.2 msec
1. Do you agree that a larger capacitor impedes the flow of current? Why or Why not?
2. In connection to item number 1, what happens to the charging and/or discharging of the
capacitor?
3. The circuit has been in position b for a long time. At time t=0, the switch is thrown to position a.
With the following given 𝑉𝑏 = 12 V, 𝐶 = 10 𝜇𝐹, R= 20 Ω. Refer to the circuit below.
a.) What is the current through the resistor just before the switch is thrown?
b.) What is the current through the resistor just after the switch is thrown?
c.) What is the charge across the capacitor just before the switch is thrown?
d.) What is the charge on the capacitor just after the switch is thrown?
e.) What is the charge on the capacitor at a time t=0.3 msec after the switch is thrown?
Answer key:
a.) I=0
b.) I= 0.6 A
c.) Q= 0
d.) Q=0
e.) 93.2 µC
V. Enrichment
Your enrichment activity will be in a short test that will be posted in Moodle.
Power point
Hand-outs
Arevalo, R. (2017). General Physics 1. Diwa Learning Systems, Inc. Makati City, Philippines. pp
93-97
https://www.electronicshub.org/wp-content/uploads/2015/03/6.Example-of-kirchoffs-voltage-
law.jpg
https://www.youtube.com/watch?v=SKdK_L4jbV0
https://www.youtube.com/watch?v=6sVeFqlSV4A
https://web.pa.msu.edu/courses/2000fall/phy232/lectures/rccircuits/rc.html
http://engineering.sdsu.edu/~johnston/EE204_PDF_Slides/Chapters%208-10/CH09.pdf
General Physics 2
_________________________________
Parent’s/Guardian’s Name & Signature