0% found this document useful (0 votes)
238 views

Data Sheet: Vykon HVAC I/O Modules

Vykon Modbus

Uploaded by

fairguy80
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
238 views

Data Sheet: Vykon HVAC I/O Modules

Vykon Modbus

Uploaded by

fairguy80
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Vykon HVAC

I/O Modules - Summary


DATA SHEET
Product Overview
The Vykon HVAC range of I/O modules are
designed for use as local I/O within motor
control cabinets or as remote I/O connected via
RS485 Modbus. The wide variety of modules
enables cost-effective use in a range of
applications, and LED’s plus Hand/Off/Auto
switches on some varieties help with
commissioning. The IP20 rated modules may
be plugged together on standard DIN rail or
direct mounting; the cascadable design allows
power and 2-wire RS485 Modbus
communications to connect through without
any extra wiring. Features
Connectivity • 7 different Digital Input, Digital Output,
Each module has one 2-wire RS485 port Analogue Input, Analogue Output
supporting a Modbus communications network I/O module varieties
®
connection to the JACE controller. • Multi-function I/O module varieties available
• Power and communications connection to
Engineering each module supplied from the CON and
Configuration and engineering of each module CON-R modules
is performed using Vykon HVAC.
• DIN rail or direct mounting
Module varieties • 24v ac or dc power operation
The following module varieties are available:
• Supports RS485 2-wire Modbus Open
• 10 Digital Input Communication network
• 8 Analogue Input
• 4 Digital Output
• Failsafe outputs to predefined state on
communications failure
• 4 Analogue Output & 3 Digital Output
• 6 Digital Output & 12 Digital Input • Easy address setting using rotary switches
• 2 HILO Output
• 4 DI, 6AI, 6DO, 2AO Multi-function
• Power & RS485 connection: CON & CON-R

To simplify wiring and reduce the risk of


misconnection the CON and CON-R modules
are used in association with the I/O modules.

Vykon HVAC
I/O Modules
Summary
DATA SHEET
Vykon HVAC Module Summary Issue 2
Vykon HVAC
IO Modules - Summary
DATA SHEET
General data:
module power supply 20v to 28v ac or dc
module current various between 30ma and 310ma ac or 10ma and 125ma dc
operating / storage temperature 0°C to +50°C / -20°C to +70°C
CE marking Low Voltage Directive (LVD) 2006/95/EC according requirements of EN 50178
EMC directive 2004/108/EC according requirements of EN 55011 and EN 61326-1
conductor cross section 0.2 – 2.5 mm2 screw clamp connection
insulation stripping length 6 mm
mounting / installation position DIN-rail TS35 (35mm x 7.5mm) or direct mounting by M3 fixing / Any position
assembly up to 15 in a row with zero spacing
insulating material Housing: Noryl. Terminals: Polyamid 6.6 V0
flammability class UL94-V0
protection degree (DIN 40050) IP 20

Bus data:
bus protocol / interface / speed Modbus RTU / RS485, half duplex, non isolated / 19,200 bps
bus topology / max. length / bus nodes maximum Multidrop / 500m / 64
bus line termination integrated termination resistor (220Ω); activate via jumper (default: off)
bus protection built-in transient protection

Module varieties:
I/O types Order reference DI AI DO DOH AOH Comments
4AOH-3DO IOMADO 3 4 3 x change over contacts
8AI IOMAIP 8 input configuration via hardware configuration block
6DOH-12DI IOMDIO 12 6 3 x change over contacts + 3 x normally open contacts
10DI IOMDIP 10 bi-colour LED per input
4DO IOMDOP 4 4 x change over contacts
MULTI IO IOMMUL 4 6 4 2 2 mixture module
2HILO IOM2HL 8 4 4 x change over contacts configured as 2 HI-LO switching pairs

Key to I/O types


DI 24v ac/dc or volt-free contact (VFC)
AI 0-10v or 0-20mA or resistive temperature detector (RTD)
DO relay – 250v ac, 16A resistive, max power rating 4,000va
DOH relay – 250v ac, 8A resistive, max power rating 2,000va with hand-off-auto switch
AOH 0-10v with hand-auto switch and adjustable setting potentiometer output

Connector module varieties:


Module Order reference Comments
CON IOMCON power and network connection for “IOMxxx” modules with network protection and termination
(note: one required per network)
CON-R IOMCNR power and network connection for additional “IOMxxx” module locations

How to Order
Module Order reference
4AOH-3DO IOMADO
8AI IOMAIP 4AOH-3DO 8AI 6DOH-12DI 10DI
6DOH-12DI IOMDIO
10DI IOMDIP
4DO IOMDOP
MULTI IO IOMMUL
2HILO IOM2HL
CON IOMCON
CON-R IOMCNR
4DO MULTI I/O 2HILO CON CON-R

Tridium Europe Ltd


www.tridium.com 1 The Grainstore, Brooks Green Road,
Vykon HVAC Module Summary Issue 2 Coolham, West Sussex RH13 8GR, UK
T +44 (0) 1403 740290 F +44 (0) 1403 741804

You might also like