Scribd
Upload
98 views1 page

EGDT-1071: SOLIDWORKS Educational Product. For Instructional Use Only

The document is an engineering drawing for a candle stand with the following key details: 1. It includes views and details of the candle stand with overall dimensions of 6 inches by 1 inch. 2. Specific dimensions are provided for features including holes, radii, angles, and thicknesses. 3. General notes at the bottom specify that all burrs and sharp edges should be removed, dimensions are in inches unless otherwise noted, and tolerances follow ANSI standards.

Uploaded by

JC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
98 views1 page

EGDT-1071: SOLIDWORKS Educational Product. For Instructional Use Only

The document is an engineering drawing for a candle stand with the following key details: 1. It includes views and details of the candle stand with overall dimensions of 6 inches by 1 inch. 2. Specific dimensions are provided for features including holes, radii, angles, and thicknesses. 3. General notes at the bottom specify that all burrs and sharp edges should be removed, dimensions are in inches unless otherwise noted, and tolerances follow ANSI standards.

Uploaded by

JC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

4 3 2 1

4.00

B .065 .125 B
R
2.25
R.10 45°
.72 .10 .62

.75

.125
22°

1.10 C
DETAIL C
SCALE 1 : 1

.50
.50

1.00 .12 R.38


6.00 .12

.50

DETAIL B DIMENSIONS WITHOUT LIMITS OR DRAWN BY


SCALE 1 : 1 JDC
A A
TOLERENCES HAVE THE
B DATE DRAWN 11/05/2021
FOLLOWING TOLERANCES
1.00 INCHES MILIMETERS CHK BY
.x +/-.1 x +/-1 PROJECT:
CHK DATE
.xx +/-.01
.xxx +/-.005
.x +/-0.1
.xx +/-0.01
SURFACE FINISH LAYOUT
EGDT-1071
ANGLES +/-.5 ANGLES +/-0.5 TITLE
GENERAL NOTES:
1.
2.
REMOVE ALL BURRS AND SHARP EDGES
UNLESS OTHERWISE SPECIFIED, ALL DIMENSIONS ARE IN INCHES
THIRD ANGLE PROJECTION UNSPEC RADII MATERIAL
GLASS
CANDLE STAND II
TARGETS WITH+/- TOLERENCES SIZE DRAWING NO REV
ARE IDEAL DIMENSIONS 12-2
DIMENSIONS AND TOLERENCES
PER ANSI Y14.5-2018
B SCALE
1:2 SHEET
1 OF 1 A

4 3 2 1
SOLIDWORKS Educational Product. For Instructional Use Only.

You might also like