Home / My courses / UGRD-IT6224-2023T / WEEK 10: MIDTERM EXAM / Midterm Exam

Started on Thursday, 21 January 2021, 7:59 AM

State Finished
Completed on Thursday, 21 January 2021, 8:53 AM
Time taken 53 mins 47 secs
Grade 45.00 out of 50.00 (90%)

Question 1
Complete

Mark 1.00 out of 1.00

Scalability Routing protocols characteristics defines how large a network can become, based on the routing protocol
that is deployed. 

Question 2
Complete

Mark 1.00 out of 1.00

What loop prevention technique is implemented by distance vector routing protocols?

Select one:
a. split horizon

b. poison reverse

c. loop guard

d. gateway of last resort

Question 3
Complete

Mark 0.00 out of 1.00

Routing Protocols   are used by routers to facilitate the exchange of routing

information between routers.

Question 4
Complete

Mark 1.00 out of 1.00

Which OPSF packet contains the different types of link-state advertisements?

Select one:
a. LSR

b. DBD

c. LSU

d. hello

Question 5
Complete

Mark 1.00 out of 1.00

Which bandwidth value is used when calculating the EIGRP metric of a route?

Select one:
a. the fastest bandwidth of all interfaces on the router 

b. the fastest bandwidth of all outgoing interfaces between the source and destination

c. the slowest bandwidth of all outgoing interfaces between the source and destination

d. the slowest bandwidth of all interfaces on the router 

Question 6
Complete

Mark 1.00 out of 1.00

Which algorithm is used by the OSPF routing process to construct the SPF tree on a router?

Select one:
a. Dijkstra's algorithm

b. Bellman-Ford algorithm

c. path vector protocol

d. DUAL algorithm
Question 7
Complete

Mark 0.00 out of 1.00

Interior Gateway Protocol used to distribute routing information

Question 8
Complete

Mark 1.00 out of 1.00

OSPF features Classless OSPFv2 is classless by design; therefore, it supports IPv4 VLSM and CIDR.

Question 9
Complete

Mark 1.00 out of 1.00

IGRP  One of the four distance vector IPv4 IGPs refers as First generation Cisco proprietary protocol (obsolete and
replaced by EIGRP)

Question 10
Complete

Mark 1.00 out of 1.00

Two routers, R1 and R2, have established an EIGRP neighbor relationship, but there is still a connectivity problem. Which issue could be
causing this problem??

Select one:
a. automatic summarization that is disabled on both routers

b. an authentication mismatch

c. an access list that is blocking advertisements from other networks

d. a process ID mismatch
Question 11
Complete

Mark 1.00 out of 1.00

OSPF features, Efficient Routing changes trigger routing updates (no periodic updates). It uses the SPF algorithm to
choose the best path.

Question 12
Complete

Mark 1.00 out of 1.00

When would the network administrator use the ip bandwidth-percent eigrp as-number percent command?

Select one:
a. when the link is always busy

b. when the connection is serial instead of Ethernet

c. when there is a low bandwidth connection

d. when the connection is on a shared medium

Question 13
Complete

Mark 1.00 out of 1.00

What is the purpose of the EIGRP Null0 summary route?

Select one:
a. to enhance security by hiding all internal networks that are included in a summary route

b. to prevent routing loops for destination networks which do not actually exist but are included in a summary route

c. to ensure that all traffic destined for individual subnets uses one single best path

d. to reduce bandwidth consumption  for traffic that is leaving the network

Question 14
Complete

Mark 1.00 out of 1.00

What is the default maximum amount of bandwidth that EIGRP uses for EIGRP control information considering an interface configured for
128 kbps?

Select one:
a. 32 kbps

b. 16 kbps

c.   128 kbps

d. 64 kbps

Question 15
Complete

Mark 1.00 out of 1.00

What address and wild card mask can be used to enable EIGRP for only the subnet 192.168.100.192 255.255.255.192?

Select one:
a. 192.168.100.192 0.0.0.15

b. 192.168.100.192 0.0.0.63

c. 192.168.100.192 0.0.0.127

d. 192.168.100.192 0.0.0.7

Question 16
Complete

Mark 1.00 out of 1.00

The wildcard mask that is used to advertise exactly the network 192.168.160.0 with subnet mask 255.255.240.0 is
0.0.15.255

Question 17
Complete

Mark 1.00 out of 1.00

  EIGRP  One of the four distance vector IPv4 IGPs refers as Advanced version of distance vector routing
Question 18
Complete

Mark 1.00 out of 1.00

The OSPF Type 1 packet is the hello packet.

Question 19
Complete

Mark 1.00 out of 1.00

Which routing protocol uses the DUAL algorithm and sends multicast messages to propagate routing updates?

Select one:
a. RIPv1

b. RIPv2

c. OSPF

d. EIGRP

Question 20
Complete

Mark 1.00 out of 1.00

Which statement is correct about multiarea OSPF?

Select one:
a. All routers are in one area called the backbone area (area 0).

b. OSPF can consolidate a fragmented OSPF area into one large area.

c.
  OSPF multiarea increases the frequency of SPF calculation.

d. Arranging routers into areas partitions a large autonomous system in order to lighten the load on routers.
Question 21
Complete

Mark 1.00 out of 1.00

Which protocol number is used to indicate that an EIGRP packet is encapsulated in an IP packet?

Select one:
a. 89

b. 17

c. 6

d. 88

Question 22
Complete

Mark 1.00 out of 1.00

A network administrator is analyzing the differences between an EIGRP hold timer and EIGRP hello interval. What statement is valid about
EIGRP hello and hold timers?

Select one:
a. EIGRP hello timers specify the maximum time that the router should wait to receive the next hello.?

b. EIGRP hello intervals and hold timers must match between EIGRP neighbors to form an EIGRP adjacency.

c. EIGRP hello intervals should be less than or equal to EIGRP hold timers.

d. EIGRP hold timers specify the minimum time that the router should wait to send the next hello.

Question 23
Complete

Mark 1.00 out of 1.00

Which classless routing protocol supports VLSM and CIDR, supports manual route summarization, and uses the multicast address 224.0.0.9?

Select one:
a. EIGRP

b. RIPv2

c. OSPF

d. RIPv1
Question 24
Complete

Mark 1.00 out of 1.00

Link-state routing protocols apply Dijkstra’s algorithm to calculate the best path route.

Question 25
Complete

Mark 1.00 out of 1.00

The OSPF hello timer has been set to 15 seconds on a router in a point-to-point network. By default, what is the dead interval on this router?

Select one:
a.   15 seconds

b. 60 seconds

c. 45 seconds

d. 30 seconds

Question 26
Complete

Mark 1.00 out of 1.00

Which interior routing protocol uses protocol-dependent modules (PDMs)?

Select one:
a. OSPF

b.   IS-IS

c. EIGRP

d. RIP
Question 27
Complete

Mark 1.00 out of 1.00

A network technician issues the following commands when configuring a router:

R1(config)# router ospf 11

R1(config-router)# network 10.10.10.0 0.0.0.255 area 0

 What does the number 11 represent?

Select one:
a. the cost of the link to R1

b. the autonomous system number to which R1 belongs

c. the administrative distance that is manually assigned to R1

d. the area number where R1 is located

e. the OSPF process ID on R1

Question 28
Complete

Mark 1.00 out of 1.00

Which multicast address does an EIGRP-enabled router use to send query packets?

Select one:
a. 224.0.0.12

b. 224.0.0.10

c. 224.0.0.5

d. 224.0.0.9
Question 29
Complete

Mark 1.00 out of 1.00

How can a network administrator reduce SPF overhead on OSPF routers?

Select one:
a. Reduce the interface delay values.

b. Decrease the hello timer intervals.

c.   Increase the number of neighbor adjacencies.

d. Implement multiple areas of OSPF.

Question 30
Complete

Mark 1.00 out of 1.00

A router is running an EIGRP process and obtaining updates from other routers. What is an indication within the routing table that a route is
a candidate for a default route?

Select one:
a. EX

b. 90

c. *

d. D

e. 170

Question 31
Complete

Mark 1.00 out of 1.00

RIPv2 One of the four distance vector IPv4 IGPs refers as Simple distance vector routing protocol

Question 32
Complete

Mark 0.00 out of 1.00

Classful Routing protocols characteristics do not include the subnet mask and cannot support VLSM.
Question 33
Complete

Mark 1.00 out of 1.00

Which routing protocol uses both bandwidth and delay to determine the best pathway to reach a remote network?

Select one:
a. IS-IS

b. RIP

c. EIGRP

d. OSPF

Question 34
Complete

Mark 1.00 out of 1.00

Which operation feature is different between EIGRP and RIP?

Select one:
a. EIGRP stores all routes learned from neighbors in a topology table.

b. EIGRP has a metric of hop count.

c.
  EIGRP sends broadcast updates to neighbors.

d. EIGRP uses periodic update timers.

Question 35
Complete

Mark 1.00 out of 1.00

The command clear ip ospf Process   forces a router with a new or changed router ID to form new adjacencies.
Question 36
Complete

Mark 1.00 out of 1.00

What is a disadvantage of using EIGRP automatic summarization?

Select one:
a.   It prevents convergence of the routing table.

b.
  It increases the number of routes in the routing table.

c. It creates inconsistent routing when the network has discontiguous networks.

d.   It increases the size of routing updates.

Question 37
Complete

Mark 1.00 out of 1.00

Resource usage  Routing protocols characterisitics includes the requirements of a routing protocol such

as memory space (RAM), CPU utilization, and link bandwidth utilization. 

Question 38
Complete

Mark 1.00 out of 1.00

Speed of convergence Routing protocols characteristic defines how quickly the routers in the

network topology share routing information and reach a state of consistent knowledge.

Question 39
Complete

Mark 1.00 out of 1.00

RIPv1 One of the four distance vector IPv4 IGPs refers as the First generation legacy protocol
Question 40
Complete

Mark 1.00 out of 1.00

Which EIGRP parameter must match between all routers forming an EIGRP adjacency?

Select one:
a.   hold timer

b. administrative distance

c. autonomous system number

d.   hello timer

e. variance

Question 41
Complete

Mark 1.00 out of 1.00

A network administrator configures a loopback interface as the OSPF router ID with the IP address of 192.168.1.1/30. What could be the
consequence of using this 30-bit mask for the loopback interface?

Select one:
a. This loopback interface may be advertised as a reachable network.

b. OSPF routers must also be configured with a router priority value.

c. Older routers do not recognize the router-id command.

d.
  The interface is not enabled for OSPF.
Question 42
Complete

Mark 1.00 out of 1.00

In the command router eigrp 100, what does the value 100 represent?

Select one:
a. the metric

b. the administrative distance

c. the autonomous system number

d. the router ID

Question 43
Complete

Mark 1.00 out of 1.00

used to confirm the reliable delivery of a packet.

Select one:
a. HELLO 

b. REPLY 

c. UPDATE 

d. ACKNOWLEDGEMENT 

Question 44
Complete

Mark 1.00 out of 1.00

Which routing protocol uses the Diffusing Update Algorithm to install routes into the routing table?

Select one:
a. OSPF

b.   BGP

c. EIGRP

d. RIP
Question 45
Complete

Mark 1.00 out of 1.00

Implementation and Mainten  Routing protocols characteristics describes the level of knowledge that is required for a network
administrator to implement and maintain the network based on the routing protocol deployed.

Question 46
Complete

Mark 1.00 out of 1.00

What is an advantage of OSPF compared to RIP?

Select one:
a. low memory requirements

b. less CPU processing

c. less complexity

d. fast convergence

Question 47
Complete

Mark 1.00 out of 1.00

Which command will limit the bandwidth that is used by EIGRP process 1 to 20%? ip bandwidth-percent eigrp

Question 48
Not answered

Marked out of 1.00

OSPF features, It quickly propagates network changes

Question 49
Complete

Mark 1.00 out of 1.00

Which routing protocol was designed by the International Organization for Standardization (ISO)?

Select one:
a. IS-IS

b. OSPF

c. EIGRP

d. RIP

Question 50
Complete

Mark 0.00 out of 1.00

IS-IS used to form an EIGRP neighbor relationship

◄ Midterm Quiz 2

Jump to...

Week 11: Multiarea OSPF, OSPF Tuning and Troubleshooting Part 1 ►