0% found this document useful (0 votes)
547 views

1D Barcode Scanner: Quick Start Guide

This document provides an overview and troubleshooting guide for a 1D barcode scanner. It includes instructions on connecting the scanner via USB or RS-232 cable, indicator lights and beeps, scanning angle, and setting decode parameters. The guide addresses common issues like continuous beeping, alarm sounds, and no data upload and provides solutions such as changing the USB port, restoring defaults, or checking the cable and power connections.

Uploaded by

jorgemir2323
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
547 views

1D Barcode Scanner: Quick Start Guide

This document provides an overview and troubleshooting guide for a 1D barcode scanner. It includes instructions on connecting the scanner via USB or RS-232 cable, indicator lights and beeps, scanning angle, and setting decode parameters. The guide addresses common issues like continuous beeping, alarm sounds, and no data upload and provides solutions such as changing the USB port, restoring defaults, or checking the cable and power connections.

Uploaded by

jorgemir2323
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Scanner Overview Plug & Unplug Cable

Plug in as shown above Press the tab until it clicks, then


pull out the cable

Connection Guide

NOTE: Product appearance may vary

1D Barcode Scanner Scanning Angle Correct Scan Method Troubleshooting Q & A


Quick Start Guide
Q1: USB bar code scanner gives a continous beeping sound
after scanner with no data uploaded.

A1: Unplug the plug to the scanner from USB port and plug it
into a different USB port or reset the interface mode to
“USB HUD Keyboard.”
Contents: Barcode Scanner, Quick Start Guide, USB/RS 232 Cable
Power Adapter (optional) Q2: USB bar code scanner makes alarm buzzer sound and no
data is uploaded.

Lights Indicator A2: Restore factory default

LED indication Explanation Q3: No laser beam or LED light after connection via RS232
Blue light blinking Decoding Successfully
Red light ON Standby status A3: Refer to Data Cable Connection guide in this manual and
check power supply.
Beeps Q4: No data uploaded and alarm buzzer after scanning via
RS232.
Beep indication Explanation
One beep Decoding Successfully A4: Terminal should have software to transfer data when
Three beeps USB Data transfer failed using RS232.
Four beeps Power ON
Continuous beep Successful parameter setting NOTE: Laser beam or Red LED light should fully
cover the bar code
Decode Settings - Set Up Function Bar Codes Interface Mode
Code39 Settings
Default Parameters e

Automatically

Numeric Keypad
Auto Trigger (optional)

Suffix Values Trigger Mode Keyboard Language


Choose a keyboard layout according to your system
UPC Settings
language settings.

Decode Mode

You might also like