Scribd
Upload
169 views

Experiment-2 - Nodal Analysis Method

This document describes an experiment to determine unknown node voltages in a DC circuit using nodal analysis. The circuit diagram shows a power supply and three resistors. Experimental data was collected by measuring the voltage at node B for different power supply voltages. Nodal analysis was used to calculate the expected voltage at node B, which was then compared to the measured value. The results showed good agreement between the calculated and measured voltages, validating the use of nodal analysis to solve for voltages in the circuit.

Uploaded by

Mahomuda Akter
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
169 views

Experiment-2 - Nodal Analysis Method

This document describes an experiment to determine unknown node voltages in a DC circuit using nodal analysis. The circuit diagram shows a power supply and three resistors. Experimental data was collected by measuring the voltage at node B for different power supply voltages. Nodal analysis was used to calculate the expected voltage at node B, which was then compared to the measured value. The results showed good agreement between the calculated and measured voltages, validating the use of nodal analysis to solve for voltages in the circuit.

Uploaded by

Mahomuda Akter
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

(Established in 1991.

Approved by the Government of Bangladesh)


Founder: Prof Dr M Alimullah Miyan
NAME: -
ID No: -
Group No: -
Program: Date: / /2021
1. EXPERIMRNT NO: -02
2. Name of the Experiment: - Determination of unknown node voltage of a D.C. circuit and verify it by Nodal analysis
method.
3. CIRCUIT DIAGRAM: -

4. EQUIPMENTS REQUIRED: -
a) Fixed &Variable D.C. power supply g)
(VA=E1, Vc=E2=5V) h)
b) Resistor. R1= 100Ω, R2=200Ω, R3=300Ω. i)
c) Multimeter j)
d) Connecting wire k)
f) Project Board l)
m)

5. EXPERIMENTAL DATA:-

VB(Calculated)

VA=E1 VB V A−V B V C −V B V B Error=VB(Measured) -VB(Calculated)


(Volt) (Measured) + =
R1 R3 R2
Sl no
10−V B 5−V B V B
+ =
1 10 6.36 100 300 200 =6.36-6.36=0
=6.36V
13−V B 5−V B V B
+ =
2 13 8 1 3 2 =8-8=0
=8V
16−V B 5−V B V B
+ =
3 16 9.64 1 3 2 =9.64-9.636=0.004
=9.636V
19−V B 5−V B V B
+ =
4 19 11.3 100 300 200
=11.272V
22−V B 5−V B V B
+ =
5 22 12.9 100 300 200
=12.909V

Instructor: Md, Turiqul Islam


(Established in 1991. Approved by the Government of Bangladesh)
Founder: Prof Dr M Alimullah Miyan

6. MATHMATICAL CALCULATION (While writing report):-

7. RESULTS:-

Instructor: Md, Turiqul Islam

You might also like