300-710 Dumps Securing Networks With Cisco Firepower (SNCF)
300-710 Dumps Securing Networks With Cisco Firepower (SNCF)
300-710 Dumps
https://www.certleader.com/300-710-dumps.html
NEW QUESTION 1
Which protocol establishes network redundancy in a switched Firepower device deployment?
A. STP
B. HSRP
C. GLBP
D. VRRP
Answer: A
NEW QUESTION 2
Which policy rule is included in the deployment of a local DMZ during the initial deployment of a Cisco NGFW through the Cisco FMC GUI?
A. a default DMZ policy for which only a user can change the IP addresses.
B. deny ip any
C. no policy rule is included
D. permit ip any
Answer: C
NEW QUESTION 3
Which command is run on an FTD unit to associate the unit to an FMC manager that is at IP address 10.0.0.10, and that has the registration key Cisco123?
Answer: D
NEW QUESTION 4
Which two actions can be used in an access control policy rule? (Choose two.)
Answer: AB
NEW QUESTION 5
What is the result of specifying of QoS rule that has a rate limit that is greater than the maximum throughput of an interface?
Answer: B
NEW QUESTION 6
What is the benefit of selecting the trace option for packet capture?
Answer: C
NEW QUESTION 7
Which action should be taken after editing an object that is used inside an access control policy?
Answer: C
NEW QUESTION 8
Which command is entered in the Cisco FMC CLI to generate a troubleshooting file?
A. show running-config
B. show tech-support chassis
C. system support diagnostic-cli
D. sudo sf_troubleshoot.pl
Answer: D
Explanation:
41 Which CLI command is used to control special handling of ClientHello messages?
A. system support ssl-client-hello-tuning
B. system support ssl-client-hello-display
C. system support ssl-client-hello-force-reset
D. system support ssl-client-hello-enabled
NEW QUESTION 9
Which command must be run to generate troubleshooting files on an FTD?
Answer: B
NEW QUESTION 10
Which limitation applies to Cisco Firepower Management Center dashboards in a multidomain environment?
A. Child domains can view but not edit dashboards that originate from an ancestor domain.
B. Child domains have access to only a limited set of widgets from ancestor domains.
C. Only the administrator of the top ancestor domain can view dashboards.
D. Child domains cannot view dashboards that originate from an ancestor domain.
Answer: D
NEW QUESTION 11
Which two features of Cisco AMP for Endpoints allow for an uploaded file to be blocked? (Choose two.)
A. application blocking
B. simple custom detection
C. file repository
D. exclusions
E. application whitelisting
Answer: AB
NEW QUESTION 12
Which two remediation options are available when Cisco FMC is integrated with Cisco ISE? (Choose two.)
Answer: CD
NEW QUESTION 13
......
100% Pass Your 300-710 Exam with Our Prep Materials Via below:
https://www.certleader.com/300-710-dumps.html