Scribd
Upload
607 views

Api 7K & ASTME 165E/E709

This document outlines inspection criteria and procedures for lifting equipment. It lists the equipment details, applicable standards, and a checklist for inspecting general requirements, field inspection items, and periodic inspection items. Inspections include visual checks for damage or wear, measurement of components, non-destructive testing of parts, and verification of documentation and manufacturer specifications. Inspection results and remarks are recorded for acceptance or rejection of the equipment.

Uploaded by

engmuhmud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
607 views

Api 7K & ASTME 165E/E709

This document outlines inspection criteria and procedures for lifting equipment. It lists the equipment details, applicable standards, and a checklist for inspecting general requirements, field inspection items, and periodic inspection items. Inspections include visual checks for damage or wear, measurement of components, non-destructive testing of parts, and verification of documentation and manufacturer specifications. Inspection results and remarks are recorded for acceptance or rejection of the equipment.

Uploaded by

engmuhmud
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Equipment Owner Type / Model

Manufacturer Serial
Manufacture Date Capacity / SWL
Reference Specification API 7K & ASTME 165E/E709 Standard Lifting Procedure

A R
Final Result
(A: Accept / R: Reject)

Item Inspection Criteria RESULTS


Pass Fail N/A Comments
1 General Requirements

1.1 Equipment documents are available


1.2 Previous inspection reports are checked

1.3 Serial number and Rated Load are clearly marked or


tagged
2 FIELD INSPECTION

2.1 Visually check the bands for any bends, twists, damage
or cracks.
Carefully check the correct installation, alignment and
2.2 adjustment of the brake linkage system according to
the manufacturer’s recommendation.
Perform NDT on the brake bands (dead and live end)
and all connecting items such as brackets (including
2.3 pin sand holes),extension rods, equalizer beam with
pin sand brackets, eyebolts, bearing blocks (including
the fastening bolts and nuts).

2.4 Check for the correct length, position and condition of


the main brake lever.
Visually check the brake rims for grooving defects,
2.5 uneven wear or cracks as per IADC drilling work
instructions.

2.6 Measure and record the wear, brake rim and water
jacket thickness.
2.7 Reassemble all items and repaint as required
2.8 Prepare and submit the inspection report
3 PERIODIC INSPECTION & REPORTING

Completely disassemble the brake system and


3.1 measure and record all items and compare with wear
limits as per relevant standards

3.2 Perform NDT on all main components as per


manufacturer’s work instructions
3.3 Prepare and submit the inspection report

REMARKS

You might also like