Scribd
Upload
70 views2 pages

Warnings For Operating The Equipment: Operator Manual

This document provides safety guidelines for operating medical electronic equipment. Key points include: 1. Only trained personnel should operate x-ray equipment and adequate protections must be used. 2. Equipment should be installed in dry, stable areas away from chemicals and protected from environmental factors. 3. Before each use, operators must check that all connections and wires are secure and the equipment is functioning properly without risk of injury to patients.

Uploaded by

NGUYEN MEDICAL
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
70 views2 pages

Warnings For Operating The Equipment: Operator Manual

This document provides safety guidelines for operating medical electronic equipment. Key points include: 1. Only trained personnel should operate x-ray equipment and adequate protections must be used. 2. Equipment should be installed in dry, stable areas away from chemicals and protected from environmental factors. 3. Before each use, operators must check that all connections and wires are secure and the equipment is functioning properly without risk of injury to patients.

Uploaded by

NGUYEN MEDICAL
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Operator manual REX-***R(F)

Warnings for operating the equipment


In order to maintain this equipment in good condition for long time, please make sure
to operate as following [Important matters in using medical electronic equipment
(safety and risk prevention)].

Medical electronic equipment (Safety and protection) Check list

1. It is important that everyone working with X-radiation be properly trained and


take adequate steps to insure protection against injury
2. When you install the machine, be cautious in following situation:
⑴ Install the equipment in a dry area.
⑵ Install the equipment where it will not be exposed to atmospheric pressure,
temperatures, humidity, ventilation, sunlight, dust, salt content, sulfur.
⑶ Be cautious to keep the equipment steady and level. Avoid slopes,
earthquakes and shocks (during movement)
⑷ Do not install the equipment around chemical, drug or gas storage .
⑸ Be careful about electric frequency, voltage or numerical value.
⑹ Ground the wire properly.

3. Before using the equipment:


⑴ Make sure the connection of buttons and check polarity to check proper
and accurate operation of the equipment.
⑵ Make sure the ground wire is fully connected.
⑶ Make sure that all the wires are properly and completely connected.
⑷ You may make a wrong diagnosis or cause injury if equipment is operated
simultaneously.
⑸ Double check the exterior circuit which touches the patient directly.

4. When using the equipment:


⑴ Don’t over use the equipment during diagnose, treatment.
⑵ Check the patient and machine all the time. Use proper protective
equipment for safe to a patient and an operator.
⑶ If you find error on with the equipment or indisposition of patient, stop the
machine under safe condition.
⑷ You must be careful to protect the patient from injury by operating
equipment.

LISTEM Corporation 5/90


Operator manual REX-***R(F)

5. After using the equipment, be careful with following.


⑴ Turn off the machine after all the buttons and shuttles are placed in original
position.
⑵ Do not force to unplug power cord.
⑶ Be cautious with storage on following.
(ⅰ) Do not store in wet place.
(ⅱ)Avoid Installation of the equipment where exposed to atmospheric
pressure, temperatures, humidity, ventilation, direct sunlight, dust, salt
content, sulfur.
(ⅲ) Be cautious to keep the equipment steady and level. Avoid slopes,
earthquakes and shocks (during movement)
(ⅳ) Do not install the equipment around chemical, drug or gas storage .
⑷ Keep and arrange the parts, and cords etc clean and neat.
⑸ Always keep the equipment clean.
6. Always mark “out of order” if the equipment is not working properly.
And contact service center.
7. Do not make alteration or conversion on the product.
8. Repair & Inspection
⑴ Must have periodical inspection on the equipment and parts.
⑵ If the equipment is not operated for long time, make sure it operates
properly before use.
9. Operate properly according to user manual.

LISTEM Corporation 6/90

You might also like