Scribd
Upload
714 views

Flow Chart For Singly Reinforced Beams

This document provides steps for analyzing and designing singly reinforced concrete beams according to ACI318M-14 standards. The steps include: 1) assuming beam dimensions and effective depth, 2) calculating the required steel area to resist bending moments, 3) determining the number of steel bars needed and their total area, 4) checking minimum reinforcement requirements, 5) computing the depth of the neutral axis and nominal moment capacity, 6) checking steel strain limits, 7) calculating strength reduction factors, and 8) ensuring the design moment exceeds the required moment.

Uploaded by

Rekan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
714 views

Flow Chart For Singly Reinforced Beams

This document provides steps for analyzing and designing singly reinforced concrete beams according to ACI318M-14 standards. The steps include: 1) assuming beam dimensions and effective depth, 2) calculating the required steel area to resist bending moments, 3) determining the number of steel bars needed and their total area, 4) checking minimum reinforcement requirements, 5) computing the depth of the neutral axis and nominal moment capacity, 6) checking steel strain limits, 7) calculating strength reduction factors, and 8) ensuring the design moment exceeds the required moment.

Uploaded by

Rekan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Analysis and Design of Singly Assume dimensions of the beam

Reinforced Beams - Depth, h ≥ ACI318M-14 Table 9.3.1.1


-Width, b ≈ 0.5 h - 0.67 h
ACI318M-14
Compute effective depth, d
Assume jd = 0.9 d

Calculate As,req
Mu ≤ Md
Md = ∅As fy jd
𝑴𝒖
𝑨𝒔,𝒓𝒆𝒒 =
∅ 𝒇𝒚 𝒋𝒅

Find number of bars and As,prov


As,req
n≥ Ab
, Check spacing

As,prov = n Ab

Check minimum reinforcement


𝑓𝑐′
4 𝑓𝑦
𝑏𝑤 𝑑
As,prov ≥ As,min
1.4
fy
𝑏𝑤 𝑑

Find a,c
𝐴𝑠 𝑓𝑦
𝑎=
0.85 𝑓𝑐′ 𝑏
𝑎
𝑐=
𝛽1

Compute Nominal Moment


𝒂
𝑴𝒏 = 𝑨 𝑺 𝒇 𝒚 𝒅 −
𝟐

Find reinforcement tensile strain


𝑑−𝑐
𝜀𝑡 = 0.003
𝑐

Check Failure Modes & compute reduction factor ,∅

Calculate desined moment


Md = ∅ Mn
Md ≥ Mu

You might also like