Scribd
Upload
350 views

Packet Tracer - Basic Device Configuration: Topology

This document provides instructions for a Packet Tracer activity where the student will configure basic settings on a router and switch, including IP addresses, passwords, and descriptions for interfaces. The objectives are to complete the network documentation, perform basic device configurations, and verify connectivity between all devices by testing IPv4 and IPv6 connectivity between the router, switch and hosts. Requirements include providing missing information in an addressing table, configuring devices according to the table, saving configurations, troubleshooting any issues, and verifying full end-to-end connectivity.

Uploaded by

Julian Camilo Guerrero Alvarado
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
350 views

Packet Tracer - Basic Device Configuration: Topology

This document provides instructions for a Packet Tracer activity where the student will configure basic settings on a router and switch, including IP addresses, passwords, and descriptions for interfaces. The objectives are to complete the network documentation, perform basic device configurations, and verify connectivity between all devices by testing IPv4 and IPv6 connectivity between the router, switch and hosts. Requirements include providing missing information in an addressing table, configuring devices according to the table, saving configurations, troubleshooting any issues, and verifying full end-to-end connectivity.

Uploaded by

Julian Camilo Guerrero Alvarado
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Packet Tracer - Basic Device Configuration

Topology
You will receive one of three possible topologies.

Addressing Table
Device Interface IP Address Default Gateway

G0/0 N/A

G0/1 N/A

VLAN 1
VLAN 1
NIC

NIC

NIC

NIC

Objectives
 Complete the network documentation.
 Perform basic device configurations on a router and a switch.
 Verify connectivity and troubleshoot any issues.

Scenario
Your network manager is impressed with your performance in your job as a LAN technician. She would like
you to demonstrate your ability to configure a router that connects two LANs. Your tasks include configuring
basic settings on a router and a switch using the Cisco IOS. You will also configure IPv6 addresses on
network devices and hosts. You will then verify the configurations by testing end-to-end connectivity. You goal
is to establish connectivity between all devices.

 2013 - 2021 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 1 of www.netacad.com
Packet Tracer - Basic Device Configuration

Note: The VLAN1 interface on will not be reachable over IPv6.


In this activity you will configure the router, switch, and the .
Note: Packet Tracer will not score some configured values, however these values are required to accomplish
full connectivity in the network.

Requirements
 Provide the missing information in the Addressing Table.
Note: Some of the information is provided in the Packet Tracer instructions for your topology.
 Name the router and the second switch . You will not be able to
access the switch.
 Use cisco as the user EXEC password for all lines.
 Use class as the encrypted privileged EXEC password.
 Encrypt all plaintext passwords.
 Configure an appropriate banner.
 Configure IPv4 and IPv6 addressing for the switch according to the Addressing Table.
 Configure IPv4 and IPv6 addressing for the switch according to the Addressing Table.
 The hosts are partially configured. Complete the IPv4 addressing, and fully configure the IPv6
addresses according to the Addressing Table.
 Document interfaces with descriptions, including the VLAN 1 interface.
 Save your configurations.
 Verify connectivity between all devices. All devices should be able to ping all other devices with IPv4
and IPv6.
 Troubleshoot and document any issues.
 Implement the solutions necessary to enable and verify full end-to-end connectivity.
Note: Click Check Results button to see your progress. Click the Reset Activity button to generate a new
set of requirements.

You might also like