0% found this document useful (0 votes)
244 views

D10T

The document provides recommended component hours and repair/inspection hours for a D10T dozer under high, medium, and low application severity. It defines the three levels of application severity and lists the base hourly rate for repairs as $46.17, assuming a 45,000 hour machine life.

Uploaded by

jogremaur
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
244 views

D10T

The document provides recommended component hours and repair/inspection hours for a D10T dozer under high, medium, and low application severity. It defines the three levels of application severity and lists the base hourly rate for repairs as $46.17, assuming a 45,000 hour machine life.

Uploaded by

jogremaur
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

TTT

Component Centerlines
Last Update- 08/13

D10T Component Hours


Component Application Severity R&I Repair
High Med Low Hours
Engine 10,000 12,000 14,000 75 190
Transmission 10,000 12,000 14,000 24 34
Torque 10,000 12,000 14,000 44 15
Bevel & Tran Gear 10,000 12,000 14,000 16 17
Final Drive 10,000 12,000 14,000 12 25
Steering Clutch & 10,000 12,000 14,000 12 14
Brake

Roller Frame 18,000 21,000 24,000 14 42


Blade Lift Cylinder 3,000 4,000 5,000 3 5
Blade Tilt Cylinder 3,000 4,000 5,000 3 5

Rate/ Hour $46.17


Assumes 80/20
No Travel Time & Mileage
$91/hr shop - $100/hr field
Base configuration machine (no ripper)(GET and hardware not included)
No fluids
Term 45,000hrs

Definitions of Application Severity


(Performance Handbook Edition 36, Section-Owning and Operating Costs)

HIGH MEDIUM LOW


 Heavy rock ripping.  Production dozing in clays,  Pulling scrapers, most
 Push loading and dozing in sands, gravels. agricultural drawbar,
hard rock.  Push loading scrapers, stockpile, & coal pile
 Working on rock surfaces. borrow pit ripping, most land applications.
 Continuous high impact clearing applications.  No Impact.
conditions.  Medium impact conditions.  Intermittent full throttle
 Production landfill work. operation.

You might also like