Scribd
Upload
2K views1 page

Compliance Statement - Steel Structure

This material submittal document provides information for steel washers, nuts, and bolts to be used for the C-108-01 Dukhan Project steel structure. It states that the proposed washers and nuts are class 8.8 & 10.9 and comply with BS EN 15048 standards. The proposed threaded rods and bars are class 8.8, comply with DIN933 and DIN976-1 standards, and will be supplied in specified sizes and lengths. Complete structural calculations will be submitted separately.

Uploaded by

Mariam Mousa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
2K views1 page

Compliance Statement - Steel Structure

This material submittal document provides information for steel washers, nuts, and bolts to be used for the C-108-01 Dukhan Project steel structure. It states that the proposed washers and nuts are class 8.8 & 10.9 and comply with BS EN 15048 standards. The proposed threaded rods and bars are class 8.8, comply with DIN933 and DIN976-1 standards, and will be supplied in specified sizes and lengths. Complete structural calculations will be submitted separately.

Uploaded by

Mariam Mousa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

MATERIAL SUBMITTAL FOR

STEEL STRUCTURE
C-108-01 DUKHAN PROJECT

C-108-01-STC-MAS-S-0002 Rev.0 06/09/2020

COMPLIANCE STATEMENT

QCS 2014 Section 16 Part 2 Structural Steadiness Material Submittal Status Remarks
Steelworks
2. MATERIALS
2.5.5 Washers Proposed materials is WASHER &
NUTS class 8.8 & 10.9 (16mm,
1. Metal washers shall be made in accordance 24mm & 30mm size) which comply
with BS 4320 Section 2. Unless otherwise as BS EN 15048 standards.
specified, black steel washers to Form E shall be
Proposed materials is full threaded
used.
long round bar HDG class. 8.8
(16mm, 24mmx2MTR) which
2. Refer to Clause 3.4.6 for washers for holding
comply as DIN933 standards.
down bolts.
Proposed materials is threaded rod
2.5.6 Lock Nuts HDG class. 8.8 (30mmx2MTR)
which comply as DIN976-1
1. Lock nuts shall be in accordance with BS 4929: standards.
Part 1. Complete and details of structural
calculation will be submitted in
separate submittals
 END OF PART

You might also like