GENIE C08 Microcontroller

Capabilities Component
The following table outlines the The GENIE C08 microcontroller has 8 legs (known as pins) and
capabilities of this GENIE device: these are used as follows (a simplified view is also shown):

Type CORE 1
2
V+ 0V
8
7
Pin Description
1 Power supply voltage (2.1-5.5V only)

C08
PR ST/G0
3 6
G4/A A/G1
4 5

Signals
G3 A/G2
2 Programming input (PR)
Pins 8 3 Analogue input A4 or digital in/out G4
3 4 Digital input G3
Analogue inputs 1

G0
7
5 Analogue input A2 or digital in/out G2
ADC resolution 8 bits 6
6 Analogue input A1 or digital in/out G1
G1/A

C08
5
G2
Digital inputs 1-4 4
G3
3 7 Digital output G0 and Status output (ST)
G4
Digital outputs 1-4 8 8 Ground (zero volt) supply voltage

Features
Parallel processing Yes The required circuit for a GENIE C08 is shown below. It
Plug and play Yes includes a download socket and two resistors.
Debug live Yes
Device control Yes
Sensor calibration Yes PR
Polyphonic music Yes ST
0V
PWM output 1
Servo motor control 0
Yes
1 8
Infra-red control 2.1-5.5V 2
V+ 0V
7
C08

PR ST/G0
3 6
Looping Yes 22k 4
G4/A A/G1
G3 A/G2
5

Events Yes
Interrupts Yes 100k

1-second clock Yes

Programming
Memory 160
Variables 10 (A-J)
EEPROM locations 16
Flowchart start limit 2
Subroutine limit No limit
Call stack limit 16

Electrical
PICmicro® device 12F683
Power supply 2.1-5.5V
Pin current limit 25mA
Total current limit 90mA

This worksheet is copyright © 2009 New Wave Concepts Limited. All rights reserved.
It may be photocopied for classroom or non-commercial use. www.genieonline.com
Page 1 of 1 ® G120 GENIE C08 Microcontroller.pdf ® Version 1.0 (July 2009)