0% found this document useful (0 votes)
81 views4 pages

Description Features: PT4452 PLL-based OOK/ASK/FSK Transmitter IC

This document describes the PT4452, a high performance OOK/ASK/FSK transmitter IC for remote keyless entry systems. The PT4452 integrates a power amplifier, one-shot circuit, and phase-locked loop with internal voltage controlled oscillator and loop filter. It operates from 2.4V to 3.6V and can transmit at frequencies between 300MHz and 450MHz with high output power of +11dBm. The one-shot circuit provides fast start-up and the chip supports on-off keying, amplitude shift keying, and frequency shift keying modulation. It is packaged in an 8-pin SOP package.

Uploaded by

Samer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
81 views4 pages

Description Features: PT4452 PLL-based OOK/ASK/FSK Transmitter IC

This document describes the PT4452, a high performance OOK/ASK/FSK transmitter IC for remote keyless entry systems. The PT4452 integrates a power amplifier, one-shot circuit, and phase-locked loop with internal voltage controlled oscillator and loop filter. It operates from 2.4V to 3.6V and can transmit at frequencies between 300MHz and 450MHz with high output power of +11dBm. The one-shot circuit provides fast start-up and the chip supports on-off keying, amplitude shift keying, and frequency shift keying modulation. It is packaged in an 8-pin SOP package.

Uploaded by

Samer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

PT4452

PLL-based OOK/ASK/FSK Transmitter IC

DESCRIPTION FEATURES
PT4452 is a high performance OOK/ASK/FSK  Highly integrated OOK/ASK/FSK transmitter
transmitter for the Remote Keyless Entry (RKE)  High output power, 3V/+11dBm/17mA
systems. It consists of a power amplifier, one-shot  Low supply voltage, 2.4V to 3.6V operation range
circuit and phase-locked loop with internal voltage  Low external component cost.
controlled oscillator and loop filter. The one-shot  PLL-based transmitter with frequency range from
circuit controls the phase-locked loop and power 300MHz to 450MHz
amplifier to have fast start-up time in operation.  On-chip one-shot circuit
 60 dB RF on-off ratio for OOK/ASK modulation
APPLICATIONS  SOP8 package

 Keyless entry systems


 Remote control systems
 Garage door openers
 Alarm systems
 Security systems
 Wireless sensors

BLOCK DIAGRAM
PAOUT VSSPA DIN VDD

8 7 6 5
Vreg Oneshot

PA

PLL

1 2 3 4

MODSEL XOUT XIN CE

Tel: 886-2-66296288‧Fax: 886-2-29174598‧http://www.princeton.com.tw‧2F, No. 233-1, Baociao Rd., Sindian Dist., New Taipei City 23145, Taiwan
PT4452

APPLICATION CIRCUIT
VDD
R3 C3

VDD
L1
ASK FSK
C4 L2
C5
1 MODSEL PAOUT 8 C6
C1
2 XOUT VSSPA 7
X1 PT4452
3 XIN DIN 6
R4 R1 DIN
C2

VDD
4 CE VDD 5

EN C7 R2
VDD

BILL OF MATERIALS
Value
Part Unit
315MHz 433.92MHz
X1 9.844M 13.56M Hz
R1 10K 10K Ohm
R2 100K 100K Ohm
R3 0 0 Ohm
R4 0 0 Ohm
C1 22p 18p F
C2 22p 18p F
C3 1μ 1u F
C4 220p 220p F
C5 8.2p 4.7p F
C6 18p 10p F
C7 2.2μ 2.2μ F
L1 180n 180n H
L2 33n 27n H
Notes:
1. C1/C2 can be used to trim the transmitted signal frequency for matching the specified value.
2. For FSK application to have adequate frequency deviation, and accurate carrier frequency, the crystal resonator frequency will be lower than the
specified value. The recommended crystal resonator frequency is 9.8388MHz and 13.5545MHz for 315MHz and 433.92MHz band. The loading
capacitor C1/C2 will put below 20pF to have ±50KHz pulling frequency deviation at least.
3. L2/C5/C6 value will depend on PCB layout.
4. The recommend maximum ESR value of X1 is 40Ω.

V1.0 2 December 2012


PT4452

ORDER INFORMATION
Valid Part Number Package Type Top Code
PT4452-S 8-Pin, SOP, 150MIL PT4452-S

PIN CONFIGURATION

PIN DESCRIPTION
Pin Name I/O Description Pin No.
MODSEL I ASK/FSK modulation selection. “0”=ASK, “1”=FSK 1
XOUT O Oscillator output 2
XIN I Oscillator input 3
CE I Chip enables. “1” to enable the chip 4
VDD P Power supply 5
DIN I Data input 6
VSSPA G Power amplifier ground 7
PAOUT O Power amplifier output 8

V1.0 3 December 2012


PT4452

IMPORTANT NOTICE
Princeton Technology Corporation (PTC) reserves the right to make corrections, modifications, enhancements,
improvements, and other changes to its products and to discontinue any product without notice at any time.
PTC cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a PTC product. No
circuit patent licenses are implied.

Princeton Technology Corp.


2F, 233-1, Baociao Road,
Sindian Dist., New Taipei City 23145, Taiwan
Tel : 886-2-66296288
Fax: 886-2-29174598
http://www.princeton.com.tw

V1.0 8 December 2012

You might also like