Scribd
Upload
49 views

1.5 Electric Power Generation From Renewable Energy Sources

Hydropower is considered a renewable energy source that uses the continuous flow of water without depletion. It is the leading renewable energy source in the US, accounting for 63% of renewable energy production in 2009. Hydroelectric power plants typically require a dam to store water and a penstock to deliver it to turbines, which convert the kinetic energy of flowing water into electrical energy. The efficiency of hydroelectric power plants is high, between 80-94% for turbines and 95-99% for generators. The Three Gorges Dam in China is currently the largest hydroelectric power plant in the world.

Uploaded by

Mai Sharaf
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views

1.5 Electric Power Generation From Renewable Energy Sources

Hydropower is considered a renewable energy source that uses the continuous flow of water without depletion. It is the leading renewable energy source in the US, accounting for 63% of renewable energy production in 2009. Hydroelectric power plants typically require a dam to store water and a penstock to deliver it to turbines, which convert the kinetic energy of flowing water into electrical energy. The efficiency of hydroelectric power plants is high, between 80-94% for turbines and 95-99% for generators. The Three Gorges Dam in China is currently the largest hydroelectric power plant in the world.

Uploaded by

Mai Sharaf
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

14 Click here to go to the Power System Analysis Home Page - PSA Publishing

1.5 ELECTRIC POWER GENERATION


FROM RENEWABLE ENERGY SOURCES

Water energy has been the most widely used form of renewable energy for the
production of electricity. With today’s emphasis on environmental considerations
and conservation of fossil fuels, other renewable resources are being used to em-
ploy the energy sources of the sun and the earth for electricity generation. Some
of these resources that represent a viable alternative to fossil fuels are solar power,
wind power, geothermal, biomass, and tidal power. These resources, especially so-
lar power and wind power, have the capability to produce sustainable energy in-
definitely with no direct emission of pollutant and greenhouse gases. Power plants
using these renewable sources of energy are described in the following sections.
The aspiration for bulk generation of power in the future is nuclear fusion. If
nuclear fusion is harnessed economically, it would provide clean energy from an
abundant source of fuel, namely water.

1.6 HYDROELECTRIC POWER PLANTS

Hydropower is considered to be a renewable energy source because it uses the con-


tinuous flow of water without using up the water resource. It is also nonpolluting,
since it does not rely on burning fossil fuels. Hydropower is currently the lead-
ing renewable energy source in the United States. In 2009, it accounted for about
63 percent of all other renewable energy sources, such as wind, solar, and biomass.
Reclamation is the nation’s second largest producer of hydroelectric power, with 58
hydroelectric power plants and 194 generating units in operation and an installed
capacity of 14,693 MW. Almost all suitable sites for dams have already been de-
veloped, so there is not much scope for further growth in water power. However,
there are numerous areas where research can lead to increases in the efficiency and
reliability of hydroelectric plants and decreases in maintenance costs. Presently,
wind and solar energy are growing at a rapid rate, and in a near future they will be
the major sources of renewable energy for production of electric power.
The hydroelectric power plants usually require a dam to store water, a pen-
stock for delivering the falling water, electric generators, a valve house which
contains the main sluice valves, automatic isolating valves, and related control
equipments. Also, a surge tank is located just before the valve house to protect
the penstock from a pressure surge, called water hammer, in case the turbine gates
are suddenly closed. In addition to electric energy production, most dams in the
United States are built for other uses, including recreation, irrigation, flood con-
trol, and public water supply. A schematic diagram of a hydroelectric power plant
is shown in Figure 1.6.
The water from the dam is led to the water turbine through the penstock, and
the potential energy of the elevated water is transformed into kinetic energy. The
water turbine converts hydraulic energy into mechanical energy, and the generator
1.6. HYDROELECTRIC POWER PLANTS 15

FIGURE 1.6
Schematic diagram of a hydroelectric power plant.

converts mechanical energy into electrical energy. After passing through the tur-
bine, the water reenters the river on the downstream side of the dam. The most
significant operating characteristics of hydropower plants are rapid start-up and
loading, long life, and low operating and maintenance costs. Hydraulic turbines,
particularly those operating with a low pressure, operate at low speed. Their gen-
erators are usually salient-type rotor with many poles. To maintain the generator
voltage frequency constant, the turbine must spin the generator at a constant speed
given by
120f
n= (1.1)
p
where f is the generated voltage frequency and p is the number of poles of the
generator.
Elaborate control schemes are used to regulate the flow of water in order to
keep the turbine speed constant.
The potential energy of the water in the reservoir is proportional to the mass
of water and the difference in height between the water impoundment and the wa-
ter outflow. This height difference is called the head or effective head. That is,
P.E. = mgh. The mass of water is its volume times its density. Therefore, P.E. =
volume × ρgh and the available hydro power becomes
P.E. volume
Pw = = ρgh (1.2)
t t
or
16

Pw = qρgh W (1.3)

q = rate of flow of water in m3 /s


h = effective head of water in m
ρ = density of water ≈ 1000 kg/m3
g = acceleration of gravity = 9.81 m/s2
Given ρ = 1000, the available hydro power P in kW is given by

P = 9.81qh kW (1.4)

If η is the overall efficiency of the hydropower plant, the electrical power output in
kW is
Po = 9.81qhη kW (1.5)

where η = ηp ηt ηg
ηp = penstock efficiency, ηt = turbine efficiency, ηg = generator efficiency

There are three basic types of hydraulic turbines. Propeller or axial turbines
are used for low heads (10 to 100 ft). A Kaplan turbine is a propeller turbine with
variable-pitch blades that can be adjusted to give high efficiency during light loads.
The Francis turbine is one of the more common radial turbines used for medium
heads (15 to 1500 ft). Fixed-blade propeller turbines and Francis turbines have rel-
atively low efficiencies at light loads. The Pelton wheel is an impulse hydraulic
turbine that is normally used for heads above 150 ft to very high heads. In gen-
eral, the hydraulic turbine efficiency during normal operation is between 80 and 94
percent, and the generator efficiency is from 95 to 99 percent.
The Three Gorges hydroelectric power plant in China is the largest develop-
ment of its kind in operation in the world. Presently, the installed capacity is 19,600
MW. When completed by the year 2011, the total electric generating capacity will
be 22,400 MW. The largest installation in North America is at La Grande on James
Bay in Canada with a total installed capacity of 7,326 MW. The largest installation
in the United States is at the Grand Coulee Dam on the Columbia River in the state
of Washington, with a total capacity of about 6,500 MW. A panoramic view of the
Grand Coulee dam is shown in Figure 1.7. Powerhouse number three is located at
the lower left side of the dam.
1.6. HYDROELECTRIC POWER PLANTS 17

FIGURE 1.7
(a) Grand Coulee Dam, ”Courtesy of Wikimedia Commons, Credit - Gregg M. Erickson.”
(b) Right Powerhouse Generators, ”Courtesy of US Bureau of Reclamation, Credit - C. Hubbard.”

Example 1.1
..
.

1.6.1 RUN-OF-THE-RIVER POWER PLANTS


..
.

1.6.2 PUMPED-STORAGE HYDRO POWER PLANTS


..
.

You might also like