International Journal of Aerospace and Mechanical Engineering (2393-8609)

Volume *– No.*, ___________ 2019

REVIEW PAPER ON A AUTOMATIC WHEEL ALIGNMENT

SYSTEM TO OVERCOME FROM WHEEL ALIGMENT
ISSUES
Arun Kumar Pundir
Chandigarh University
[email protected]
m

ABSTRACT 3.3 This paragraph is a repeat of 3.1

In this paper, we describe the formatting guidelines for Please use a 9-point Times Roman font, or other Roman font
IJAME Journal Submission. with serifs, as close as possible in appearance to Times
Roman in which these guidelines have been set. The goal is to
General Terms have a 9-point text, as you see here. Please use sans-serif or
Your general terms must be any term which can be used for non-proportional fonts only for special purposes, such as
general classification of the submitted material such as Pattern distinguishing source code text. If Times Roman is not
Recognition, Security, Algorithms et. al. available, try the font named Computer Modern Roman. On a
Macintosh, use the font named Times. Right margins should
Keywords be justified, not ragged.
Keywords are your own designated keywords which can be
used for easy location of the manuscript using any search 3.4 Title and Authors
engines. The title (Helvetica 18-point bold), authors' names (Helvetica
12-point) and affiliations (Helvetica 10-point) run across the
1. INTRODUCTION full width of the page – one column wide. We also
We ask that authors follow some simple guidelines. In recommend e-mail address (Helvetica 12-point). See the top
essence, we ask you to make your paper look exactly like this of this page for three addresses. If only one address is needed,
document. The easiest way to do this is simply to download center all address text. For two addresses, use two centered
the template, and replace the content with your own material. tabs, and so on. For three authors, you may have to improvise.
2. PAGE SIZE 3.5 Subsequent Pages
All material on each page should fit within a rectangle of 18 x For pages other than the first page, start at the top of the page,
23.5 cm (7" x 9.25"), centered on the page, beginning 2.54 cm and continue in double-column format. The two columns on
(1") from the top of the page and ending with 2.54 cm (1") the last page should be as close to equal length as possible.
from the bottom. The right and left margins should be 1.9 cm
(.75”). The text should be in two 8.45 cm (3.33") columns
with a .83 cm (.33") gutter. Table 1. Table captions should be placed above the table

3. TYPESET TEXT Graphics Top In-between Bottom

3.1 Normal or Body Text Tables End Last First

Please use a 9-point Times Roman font, or other Roman font Figures Good Similar Very well
with serifs, as close as possible in appearance to Times
Roman in which these guidelines have been set. The goal is to
have a 9-point text, as you see here. Please use sans-serif or
non-proportional fonts only for special purposes, such as 3.6 Page Numbering, Headers and
distinguishing source code text. If Times Roman is not
available, try the font named Computer Modern Roman. On a Footers
Macintosh, use the font named Times. Right margins should Do not include headers, footers or page numbers in your
be justified, not ragged. submission. These will be added when the publications are
assembled.
3.2 This paragraph is a repeat of 3.1
Please use a 9-point Times Roman font, or other Roman font 4. FIGURES/CAPTIONS
with serifs, as close as possible in appearance to Times Place Tables/Figures/Images in text as close to the reference
Roman in which these guidelines have been set. The goal is to as possible (see Figure 1). It may extend across both columns
have a 9-point text, as you see here. Please use sans-serif or to a maximum width of 17.78 cm (7”).
non-proportional fonts only for special purposes, such as Captions should be Times New Roman 9-point bold. They
distinguishing source code text. If Times Roman is not should be numbered (e.g., “Table 1” or “Figure 2”), please
available, try the font named Computer Modern Roman. On a note that the word for Table and Figure are spelled out.
Macintosh, use the font named Times. Right margins should Figure’s captions should be centered beneath the image or
be justified, not ragged. picture, and Table captions should be centered above the table

1
 International Journal of Aerospace and Mechanical Engineering (2393-8609)
Volume *– No.*, ___________ 2019

body.

Fig 1: If necessary, the images can be extended both columns

5. SECTIONS Reasoning about naming systems. .

The heading of a section should be in Times New Roman 12- [2] Ding, W. and Marchionini, G. 1997 A Study on Video
point bold in all-capitals flush left with an additional 6-points Browsing Strategies. Technical Report. University of
of white space above the section head. Sections and Maryland at College Park.
subsequent sub- sections should be numbered and flush left.
For a section head and a subsection head together (such as [3] Fröhlich, B. and Plate, J. 2000. The cubic mouse: a new
Section 3 and subsection 3.1), use no additional space above device for three-dimensional input. In Proceedings of the
the subsection head. SIGCHI Conference on Human Factors in Computing
Systems
5.1 Subsections [4] Tavel, P. 2007 Modeling and Simulation Design. AK
The heading of subsections should be in Times New Roman
Peters Ltd.
12-point bold with only the initial letters capitalized. (Note:
For subsections and subsubsections, a word like the or a is not [5] Sannella, M. J. 1994 Constraint Satisfaction and
capitalized unless it is the first word of the header.) Debugging for Interactive User Interfaces. Doctoral
Thesis. UMI Order Number: UMI Order No. GAX95-
5.1.1 Subsubsections 09398., University of Washington.
The heading for subsubsections should be in Times New
Roman 11-point italic with initial letters capitalized and 6- [6] Forman, G. 2003. An extensive empirical study of
points of white space above the subsubsection head. feature selection metrics for text classification. J. Mach.
Learn. Res. 3 (Mar. 2003), 1289-1305.
5.1.1.1 Subsubsections
The heading for subsubsections should be in Times New [7] Brown, L. D., Hua, H., and Gao, C. 2003. A widget
Roman 11-point italic with initial letters capitalized. framework for augmented interaction in SCAPE.
[8] Y.T. Yu, M.F. Lau, "A comparison of MC/DC,
5.1.1.2 Subsubsections MUMCUT and several other coverage criteria for logical
The heading for subsubsections should be in Times New decisions", Journal of Systems and Software, 2005, in
Roman 11-point italic with initial letters capitalized. press.
6. REFERENCES [9] Spector, A. Z. 1989. Achieving application requirements.
[1] Bowman, M., Debray, S. K., and Peterson, L. L. 1993. In Distributed Systems, S. Mullender