Scribd
Upload
115 views

E-Lab Instructions: ME2142 Feedback Control Systems Lab 2: Speed/Position Control of A DC Motor AY2020/2021, Semester 1

This document provides instructions for Lab 2 on speed/position control of a DC motor, which will be conducted fully online due to COVID-19. Students are to read the lab manual, study relevant concepts, watch instructional videos, write an individual report using the provided data sheet, and submit it by the deadline of September 14th. The report aims to demonstrate understanding of feedback control systems through simulation rather than physical experimentation.

Uploaded by

Cl Skye
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
115 views

E-Lab Instructions: ME2142 Feedback Control Systems Lab 2: Speed/Position Control of A DC Motor AY2020/2021, Semester 1

This document provides instructions for Lab 2 on speed/position control of a DC motor, which will be conducted fully online due to COVID-19. Students are to read the lab manual, study relevant concepts, watch instructional videos, write an individual report using the provided data sheet, and submit it by the deadline of September 14th. The report aims to demonstrate understanding of feedback control systems through simulation rather than physical experimentation.

Uploaded by

Cl Skye
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ME2142 Feedback Control Systems

LAB 2: SPEED/POSITION CONTROL OF A DC MOTOR


AY2020/2021, Semester 1

e-LAB INSTRUCTIONS
Peter C. Y. Chen
Associate Professor
Department of Mechanical Engineering
National University of Singapore

This lab will be conducted in full e-learning mode. There will be no physical experiments to be
performed by students using the equipment as described in the Lab Manual.

The following tasks are to be completed for this lab by each student, as part of the continuing
assessment of this module. All material (i.e., the Lab Manual, the Data Sheet, and the videos)
mentioned in these instructions are available on LumiNUS – either in the Files section or the
Multimedia section.

1. Read through the Lab Manual to learn about the purpose, the setup, and the equipment
used in this lab.
2. Study the concepts relevant to the experiments.
3. Watch the videos on the theoretical background and the experiment procedures
associated with this lab.
4. Write an individual lab report following the instructions as given in the Lab Manual,
using the Data Sheet provided.
5. Submit the report by uploading it into the folder Report Submission – Lab 2 Speed/Position
Control of a DC Motor on LumiNUS, as is indicated by the red arrow in the figure below.
6. The deadline for uploading the lab report is 14 September, 11:59 PM, Singapore time.

You might also like