Scribd
Upload
61 views3 pages

2018-2019 CEE2219 TM1 TermEndTest - 2018-19 PDF

This document contains a 5 question end of term test for a Statics and Mechanics of Materials course. The questions cover determining forces in truss members, forces exerted at a pinned connection, minimum force required to move a concrete block over wedges, clamping force from a tightened screw, and minimum tension in a belt to raise or lower a block over a pulley system. Students are instructed to show their work and answer all questions, which are equally weighted at 20% each.

Uploaded by

Cyrus Charteh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
61 views3 pages

2018-2019 CEE2219 TM1 TermEndTest - 2018-19 PDF

This document contains a 5 question end of term test for a Statics and Mechanics of Materials course. The questions cover determining forces in truss members, forces exerted at a pinned connection, minimum force required to move a concrete block over wedges, clamping force from a tightened screw, and minimum tension in a belt to raise or lower a block over a pulley system. Students are instructed to show their work and answer all questions, which are equally weighted at 20% each.

Uploaded by

Cyrus Charteh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

THE UNIVERSITY OF ZAMBIA

School of Engineering
Department of Civil & Environmental Engineering

CEE 2219-Statics and Introduction to Mechanics of Materials

TERM 1-Academic Year 2018/2019

END OF TERM TEST

July 2019 Time allowed: Two hours

CLOSED BOOK Examination

Instructions to candidates:

1. Candidates must ensure that their computer numbers are clearly written on each
answer sheet used
2. Answer all the FIVE questions. All questions carry equal marks (20%)

Question 1

Using the methods of sections, determine the forces in the following members of the truss in
figure 1, FI and JC. Indicate whether they are tension or compression.

1
Question 2

In the frame shown, members ACE and BCD are connected by a pin at C and by the link DE. For
the loading shown, determine the force in link DE and the components of the force exerted at C
on member BCD.

Question 3

The horizontal position of the 500-kg rectangular block of concrete is adjusted by the 5°
wedge under the action of the force P. If the coefficient of static friction for both wedge
surfaces is 0.30 and if the coefficient of static friction between the block and the horizontal
surface is 0.60, determine the least force P required to move the block

2
Question 4

Determine the clamping force on the board A if the screw is tightened with a torque of M = 8 N.
m. The square-threaded screw has a mean radius of 10 mm and a lead of 3 mm, and the
coefficient of static friction is μs = 0.35.

Question 5

The 100-mm-diameter pulley shown in Fig. a fits loosely on a 10-mm-diameter shaft for which
the coefficient of static friction is μs = 0.4. Determine the minimum tension T in the belt needed
to (a) raise the 100-kg block and (b) lower the block. Assume that no slipping occurs between the
belt and pulley and neglect the weight of the pulley.

Figure a

END OF TEST

You might also like