Scribd
Upload
526 views2 pages

HUVITZ CCP-3100 How To Change Channel

This document provides instructions for changing the channel (ID) of CCP-3100 chart projectors when multiple projectors are installed in the same room. The channel must be changed to allow individual projectors to be controlled separately. To change the channel, use dip switches 2 and 3 on the main board to select a different combination of on and off positions for each projector. Press the "C" and "Eye" buttons simultaneously on the remote control to complete the channel change and sync the remote with the new channel. Changing the channel ensures each projector can be operated independently with a single remote control.

Uploaded by

Dim Liakos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
526 views2 pages

HUVITZ CCP-3100 How To Change Channel

This document provides instructions for changing the channel (ID) of CCP-3100 chart projectors when multiple projectors are installed in the same room. The channel must be changed to allow individual projectors to be controlled separately. To change the channel, use dip switches 2 and 3 on the main board to select a different combination of on and off positions for each projector. Press the "C" and "Eye" buttons simultaneously on the remote control to complete the channel change and sync the remote with the new channel. Changing the channel ensures each projector can be operated independently with a single remote control.

Uploaded by

Dim Liakos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

<1/2>

◆ How to change channel(ID) of CCP-3100

Symptom : When you use chart projector(CCP-3100) over 1 set in the one
room, all chart projector works at the same time even you use only 1 remote
controller.

Reason : The channel(ID) of installed chart projector is same.

How to solve : Change channel of chart projector

„ Change the dip switch


‹ There’s a dip switch in the main board.

<Present main board of CCP-3100>

(※ Previous main board also has dip switch.)


‹ Use no. 2 and no 3 switch.(Don’t use other number switch.)
‹ Set dip switch
¾ There’re 4-type which you can change.
¾ For example,

2 3 2 3 2 3 2 3

( ※ : Switch on. : Switch off.)


¾ You can choose any one as above. However, all chart projector dip
switch setting which installed in the one room should be different from
each one.
<2/2>

‹ Press “C” button ( ) and “Eye” button ( ) at the same


time.

¾ Press buttons until heard beep sound.


¾ Beep sound means channel is changed and it’s possible to communicate
between remote controller and chart projector.

‹ If you can not be heard beep sound, you might use old model remote
controller. It means old model remote controller doesn’t support this
function.

‹ So try again using other remote controller which supports this function.
(If remote controller isn’t very early model, almost remote controller supports
this function.)

- End.

You might also like