Scribd
Upload
225 views

Sheet2 Solution PDF

This document contains a 17 question practice exam on electronic circuits and operational amplifiers. It includes questions about determining values for non-inverting amplifiers, calculating closed loop gain, input and output impedances, voltage followers, input offset voltage, open and closed loop gain, RC lag circuits, and bandwidth. The document provides the questions, figures to reference, and the instructor's name.

Uploaded by

Varun Bisht
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
225 views

Sheet2 Solution PDF

This document contains a 17 question practice exam on electronic circuits and operational amplifiers. It includes questions about determining values for non-inverting amplifiers, calculating closed loop gain, input and output impedances, voltage followers, input offset voltage, open and closed loop gain, RC lag circuits, and bandwidth. The document provides the questions, figures to reference, and the instructor's name.

Uploaded by

Varun Bisht
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

Benha University Electronic circuits (B) Electrical Eng. Dept.

Faculty of Engineering Page 1/2 3rd year communication


Shoubra 2012-2013
--------------------------------------------------------------
Sheet (2) - Solution
1. A non-inverting amplifier has Ri of 1KΩ and Rf of 100 KΩ. Determine Vf and
B if Vout = 5V.

2. For the non-inverting amplifier shown in figure (1). Determine Acl(NI) , Vout, and
Vf.

Figure (1)

3. Calculate the closed loop gain for non-inverting amplifier has R1=4.7KΩ,
RF=47KΩ, and AOL=150,000.
4. For an inverting amplifier with closed loop gain of -300, and R1 of 10KΩ,
calculated the value required to Rf to satisfy this gain.

5. Determine the approximate values for Iin, If, Vout, Acl in figure (2).

Figure (2)

Dr.Rokaia Mounir
6. Determine the input and output impedances for the following amplifiers of fig.3

Figure (3)

7. A voltage follower is driven by a voltage source resistance of 75Ω.


(a) What value of compensating resistor is required for bias current and where
should the resistor be placed?
(b) If the two input currents after compensation are 42μA and 40μA. What is
the output error voltage?

Dr.Rokaia Mounir
8. A particular voltage follower has an input offset voltage of 2nV. What is the
output error voltage?

9. What is the input offset voltage of an op-amp if a dc voltage of 35mV is


measured when the input voltage is zero? The opamp's open loop gain is
specified to be 200,000.

10. The midrange open-loop gain of a certain op-amp is 120dB. Negative


feedback reduces this gain by 50dB. What is the closed-loop gain?

11. The upper critical frequency of an op-amp's open loop response is 200Hz.
If the midrange gain is 175,000, what is the ideal gain at 200Hz? What is
the actual gain? What is the op-amp's open-loop bandwidth?

Dr.Rokaia Mounir
12. An RC lag circuit has a critical frequency of 8.5 KHz. Determine the phase
shift for each frequency and plot a graph of its phase angle versus frequency.
(i) 100Hz (ii) 400Hz (iii) 850Hz (IV) 8.5 KHz (v) 25 KHz.

13. An RC lag circuit has a critical frequency of 5 KHz. If the resistance value is
1KΩ. What is Xc when f=3KHz.

14. Determine the attenuation of an RC lag circuit with fc=12 KHz for 1 KHz and
100 KHz.

Dr.Rokaia Mounir
15. A certain amplifier has an open-loop gain in midrange of 180,000 and an
open-loop critical frequency of 1500Hz. If the attenuation of the path is 0.015,
what is the closed-loop bandwidth?

16. Given that fc(ol)=750Hz, Aol=89dB, and fc(cl)=5.5KHz, determine the closed
loop gain in decibels.

17. Which of the amplifiers shown in figure (4) has the smaller Bandwidth?

Figure (4)

Good Luck
Dr.Rokaia Mounir

You might also like