Scribd
Upload
70 views2 pages

Gujarat Technological University: Subject Code:140603 Date: Subject Name: Structural Analysis-II Time: Total Marks: 70

This document is an exam for a structural analysis course covering various topics: 1) Question 1 asks to distinguish between pre-tensioning and post-tensioning, and define strain energy and state Castigliano's first theorem. 2) Question 2 gives problems calculating displacements and reactions for beams and frames using given properties and loads. 3) Question 3 covers causes of side sway in portal frames, or explaining distribution factors, and analysing beams using moment distribution or consistent deformation methods. 4) Question 4 addresses advantages and disadvantages of fixed beams, or uses slope deflection or other methods to analyse continuous beams. 5) Question 5 involves Clapeyron's three moment theorem

Uploaded by

Preeti Varma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
70 views2 pages

Gujarat Technological University: Subject Code:140603 Date: Subject Name: Structural Analysis-II Time: Total Marks: 70

This document is an exam for a structural analysis course covering various topics: 1) Question 1 asks to distinguish between pre-tensioning and post-tensioning, and define strain energy and state Castigliano's first theorem. 2) Question 2 gives problems calculating displacements and reactions for beams and frames using given properties and loads. 3) Question 3 covers causes of side sway in portal frames, or explaining distribution factors, and analysing beams using moment distribution or consistent deformation methods. 4) Question 4 addresses advantages and disadvantages of fixed beams, or uses slope deflection or other methods to analyse continuous beams. 5) Question 5 involves Clapeyron's three moment theorem

Uploaded by

Preeti Varma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Seat No.: ________ Enrolment No.

___________

GUJARAT TECHNOLOGICAL UNIVERSITY


BE - SEMESTER–IV (OLD) EXAMINATION – WINTER 2018
Subject Code:140603 Date: 10/12/2018
Subject Name: Structural Analysis-II
Time: 02:30 PM TO 05:00 PM Total Marks: 70
Instructions:
1. Attempt all questions.
2. Make suitable assumptions wherever necessary.
3. Figures to the right indicate full marks.

Q.1 (a) Distinguish between : Pre-tensioning and Post tensioning 07


(b) Define strain energy. State and Prove Castigliano’s first theorem. 07
Q.2 (a) Calculate fixed end moments and draw B.M. and S.F. diagrams for a fixed beam 07
AB of span 4m and subjected to udl of 25 kN/m over the entire span.
(b) Calculate vertical displacement of point C for a rigid cantilever frame shown in 07
Fig. 1. E =2 x 105 N/mm2 and I = 3 x 108 mm4.
OR
(b) Calculate horizontal displacement of point C for a rigid cantilever frame shown 07
in Fig. 1. E =2 x 105 N/mm2 and I = 3 x 108 mm4.
Q.3 (a) List causes of side sway for portal frame. 04
(b) Using Moment Distribution method find support moments and draw B.M. and 10
S.F. diagrams for the continuous beam shown in Fig. 2
OR
Q.3 (a) Explain (i) Carry over factor (ii) Distribution Factor 04
(b) Analyse the beam shown in Fig. 3 by consistent deformation method. Draw shear 10
force and bending moment diagram. EI = constant.
Q.4 (a) Advantages and disadvantages of fixed beam. 04
(b) A continuous beam ABC is having spans AB and BC of length 4m and 3m, 10
respectively. Span AB is subjected to udl of 60 kN/m while span BC is subjected
to udl of 80 kN/m respectively. Consider support system at A, B and C is roller
(simply) support. Find the support moments and draw B.M. and S.F. diagrams.
OR
Q.4 (a) Explain Muller-Breslau principle. 04
(b) Using Slope Deflection method, determine the support moments and reactions 10
for the continuous beam shown in Fig. 4. Draw B.M. and S.F. diagrams.
Q.5 (a) State and explain Clapeyron’s theorem of three moments. 04
(b) Using Kani’s Method, determine the moments at A, B, C, D for the portal frame 10
as shown in Fig. 5
OR
Q.5 (a) List losses in prestressing. 04
(b) Draw influence line diagram for propped cantilever beam AB of length 12 m for 10
(i) Reaction at fixed end (Va) (ii) Reaction at propped end (Vb)

1
50 kN

B C
3m
100 kN 80 kN
A B C
6m (2I) (I)
3m 3m 1m 3m
Fig. 1 Fig. 2
A

30 kN 90 kN
60 kN / m
C B B
A A C
2m 3m 5m 1m 2m
Fig. 3
Fig. 4

100 kN / m

B C
(4I)

(I) 3m
(I)
A D
6m
Fig. 5

************

You might also like