Solution Network Essential Guide ch1 03
Solution Network Essential Guide ch1 03
, ISBN: 9781305105430
Ch. 3 Solutions-1
Chapter 3 Solutions
Review Questions
1. Which of the following describes the arrangement of network cabling between devices?
a. Logical topology
b. Networking technology
c. Physical topology
d. Media access method
2. Which of the following is an advantage of a star topology? (Choose all that apply.)
a. Allows faster technologies than a bus does
b. Requires less cabling than a bus
c. Centralized monitoring of network traffic
d. No single point of failure
3. Which topology is likely to be deployed in a WAN where there’s a central office and three
branch offices, and you want all traffic from the branch offices to go through the central office
network?
a. Ring
b. PMP
c. Mesh
d. Point-to-point
4. Which technology is likely to be implemented as a point-to-point physical topology?
a. Wi-Fi infrastructure mode
b. FDDI
c. Ethernet
d. Wireless bridge
5. Which of the following describes a hub-based Ethernet network?
a. Physical bus
b. Logical bus
c. Physical switching
d. Logical star
6. You’re configuring a WLAN in a long narrow ballroom. The only place you can put the AP is
at the far end of the room. Which type of antenna should you use?
a. Unidirectional
b. Bidirectional
c. Omnidirectional
d. Semidirectional
7. Which best describes a typical wireless LAN?
a. Logical ring topology
b. Logical switching topology
c. Logical bus topology
Guide to Networking Essentials, 7th ed., ISBN: 9781305105430
Ch. 3 Solutions-2
a. Token passing
b. CSMA/CD
c. Token bus
d. Polling
16. Which of the following is true about full-duplex Ethernet? (Choose all that apply.)
a. Stations can transmit and receive but not at the same time.
b. Collision detection is turned off.
c. It's possible only with switches.
d. It allows a physical bus to operate much faster.
17. Which of the following is defined by the extent to which signals in an Ethernet bus topology
network are propagated?
a. Physical domain
b. Collision domain
c. Broadcast domain
d. Logical domain
18. Which of the following is considered a property of Ethernet? (Choose all that apply.)
a. Scalable
b. Best-effort delivery system
c. Guaranteed delivery system
d. Obsolete technology
19. Which of the following is true of IEEE 802.3an?
a. Requires two pairs of wires
b. Uses Category 5 or higher cabling
c. Currently best for desktop computers
d. Operates only in full-duplex mode
20. Which of the following is a feature of 100BaseFX? (Choose all that apply.)
a. Often used as backbone cabling
b. Best when only short cable runs are needed
c. The fastest of the Ethernet standards
d. Uses two strands of fiber
21. Which Wi-Fi standard can provide the highest bandwidth?
a. 802.11ac
b. 802.11b
c. 802.11n
d. 802.11g
22. Which of the following is true about infrastructure mode in wireless networks? (Choose all
that apply.)
a. Best used for temporary networks
b. Uses a central device
c. Resembles a physical bus and logical ring
d. Most like a logical bus and physical star
Guide to Networking Essentials, 7th ed., ISBN: 9781305105430
Ch. 3 Solutions-4
23. How many channels can be used on an 802.11b network in North America?
a. 7
b. 9
c. 11
d. 13
24. Which access method does Wi-Fi use?
a. CSMA/CD
b. Token bus
c. Demand priority
d. CSMA/CA
25. Which Wi-Fi standard uses beamforming to allow an AP to send data to multiple devices
simultaneously?
a. 802.11ac
b. 802.11n
c. 802.11a
d. 802.11g