Scribd
Upload
274 views2 pages

CBE - Rear Steering Pot Setup-Rev 1

This document provides instructions for setting up the rear steer potentiometer on CBE trucks from VCL 1.00 onwards. It involves turning the rear wheel to specific angles in normal mode and recording the corresponding potentiometer values, then entering those values as parameters to calibrate the potentiometer's range of motion. Adjusting the valve blip time may also be needed if the wheel does not reach 0 degrees accurately.

Uploaded by

crash2804
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
274 views2 pages

CBE - Rear Steering Pot Setup-Rev 1

This document provides instructions for setting up the rear steer potentiometer on CBE trucks from VCL 1.00 onwards. It involves turning the rear wheel to specific angles in normal mode and recording the corresponding potentiometer values, then entering those values as parameters to calibrate the potentiometer's range of motion. Adjusting the valve blip time may also be needed if the wheel does not reach 0 degrees accurately.

Uploaded by

crash2804
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

CBE Setup Rear Steer

Potentiometer
This procedure will show you how to setup the rear steer potentiometer on CBE trucks
from VCL 1.00 – Onwards. This info might be changed for future code releases.
To view or change the parameters you will need a Curtis handheld or Curtis software on
your laptop with the Curtis lead.

• Turn the keyswitch On.


• Remove the panel on the side of the dash with a 4mm allen key to get access
to the controllers plugs.
• Connect your Curtis handheld or laptop with Curtis software to the
Master controllers plug.
• Go to Monitor > Inputs.

• Turn the rear wheel in normal mode to 90° "Steer Angle (deg") and record the
"Steer Pot" value.
• Turn the rear wheel in normal mode to 0° "Steer Angle (deg") and record
the "Steer Pot" value.
• Turn the rear wheel in normal mode to -90° "Steer Angle (deg") and record the
"Steer Pot" value.

• Go to Parameters > Dual Drive > Master.


• Change "Steer Pot Max" to the value you recorded for 90°. Minus 0.02 from
the value.
• Change "Steer Pot Zero" to the value you recorded for 0°.
• Change "Steer Pot Min" to the value you recorded for -90°. Add 0.02 to the
value.
• Go to Parameters > Combilift > Drive Setup.
• Adjust the "Valve Blip Time" if the wheel does not reach 0° or goes past 0°
when changing into normal mode.
• If the rear wheel reaches 0° in normal mode and 90° in sidewards mode then
the procedure has been completed correctly.

You might also like