Scribd
Upload
117 views

(Mini Project-Shaft Design) : The University of Jordan School of Engineering

The document is a machine design course assignment to design a shaft connecting gears that power a coal crusher and conveyor system. The shaft carries gears A, C, and E and rotates at 480 rpm. Gears A and E provide power of 15 kW and 7.5 kW respectively to the crusher and conveyor. The distance from each bearing to the nearest gear face is 100 mm. The student must design the shaft and justify any assumptions made.

Uploaded by

Mou'ath Alhajjaj
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
117 views

(Mini Project-Shaft Design) : The University of Jordan School of Engineering

The document is a machine design course assignment to design a shaft connecting gears that power a coal crusher and conveyor system. The shaft carries gears A, C, and E and rotates at 480 rpm. Gears A and E provide power of 15 kW and 7.5 kW respectively to the crusher and conveyor. The distance from each bearing to the nearest gear face is 100 mm. The student must design the shaft and justify any assumptions made.

Uploaded by

Mou'ath Alhajjaj
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

The University of Jordan

School of Engineering

Semester Course Number Course Name Department


Spring 2019/2020 0904435 Machine Design I Mechanical Engineering

(Mini project- Shaft Design)

Due Date: 17/April/2020

Submitted by:

Mou’ath Khalil Alhajjaj

Student ID :

0162226
Project outline

Project purpose 3 .1

Introduction 3 .2

Problem statement 4 .3

.4
Problem Statement

A drive for a system to crush coal and deliver it by conveyor to a railroad car is
shown below. Gear A delivers 15 kW to the crusher and gear E delivers 7.5 kW to
the conveyor. All power enters the shaft through gear C. The shaft carrying gears
A, C, and E rotates at 480 rpm. Design that shaft. The distance from the middle of
each bearing to the middle of the face of the nearest gear is 100 mm. Make
.appropriate assumptions where necessary. Justify all assumptions
C

Drive Gear Q
motor

Input

A B D E Shaft 2

Gear S
Gear
R

Output to crusher Output to conveyor

Spur gear E
62mm-dia

Spur gear C 300mm-dia

Pressure angle 20
degrees for all
gears

You might also like