Scribd
Upload
163 views2 pages

9100 Spec Sheet 1-01 PDF

Uploaded by

Ryan Valencia
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
163 views2 pages

9100 Spec Sheet 1-01 PDF

Uploaded by

Ryan Valencia
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

9100 Sensor

General Purpose

DYNAMIC FEATURES:
Sensitivity, ±5%, 25°C ______________________________ 100 mV/g Rugged, general purpose
Acceleration Range 1 _________________________________ 50 g peak
Corrosion resistant
Amplitude Nonlinearity ______________________________ 1%
Frequency Response Hermetic seal
±5% ____________________________________________0.6 - 4,000 Hz Ground isolated
±10% ___________________________________________ 0.4 - 5,000 Hz ESD and miswiring protection
±3 dB __________________________________________0.2 - 10,000 Hz
Resonance Frequency ________________________________ 20 kHz
Transverse Sensitivity, max. _________________________ 5% of axial
Temperature Response ______________________________ see graph

ELECTRICAL
Power Requirement
voltage source _________________________________18 - 28 VDC
current regulating diode 1,2 ____________________ 2 - 20 mA
Electrical Noise, equiv. g, nominal
Broadband 1 Hz to 10 kHz ______________ 50 µg
Spectral 10 Hz _______________________ 4.0 µg/√Hz
100 Hz ______________________ 0.8 µg/√Hz
1,000 Hz ____________________ 0.4 µg/√Hz
Output Impedance, max. _____________________________ 100 Ohms
Bias Output Voltage, nominal _______________________ 8 - 12 VDC
Grounding ____________________________________________case isolated, internally shielded

ENVIRONMENTAL
Temperature Range __________________________________-54 to 121°C
Shock Limit __________________________________________5,000 g peak

PHYSICAL
Weight _______________________________________________ 93 gm
Case Material ________________________________________ stainless steel
Mounting _____________________________________________ 1/4 - 28 tapped hole
Output Connector ____________________________________ MIL-C-5015, 2 pin
Pin A ___________________________________________signal, power
Pin B ___________________________________________common
T Y P I C A L T E M P E R AT U R E R E S P O N S E

Temperature

NOTES:
1 To minimize the possibility of signal distortion when driving long cables with high vibration signals, 24 to 30 VDC
powering is recommended. The higher level constant current source should be used when driving long cables
(Please consult Entek Customer Service).
2 A maximum current of 6 mA is recommended for operating temperatures in excess of 100 °C.

ACCESSORIES SUPPLIED: 1/4-28 Mounting screw, Calibration data

Ordering Information
Model Description P/N
9100 General purpose accelerometer - 100 mV/g, 0.2-10,000 Hz (3dB), 43784I
top exit, Mil Spec connector.

Entek is a registered trademark of Entek International Corporation


ICP is a registered trademark of PCB Group, Inc.
Publication ENACC-TD905A-EN-P — January 2001 © 2001 Rockwell International Corporation All Rights Reserved Printed in USA

You might also like