Scribd
Upload
172 views

Sample Purchase Specification For Clariflocculator

The document specifies requirements for a bridge mechanism with a scraper to remove settled sludge from the bottom of a clariflocculator. The bridge will span half the diameter of the clariflocculator and have a 1:12 bottom slope. It will be made of MS steel coated with protective paints and have accessories like a weir plate and hand rails. A 415V three-phase motor with IP68 protection will power the mechanism.

Uploaded by

contactdevansh1174
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
172 views

Sample Purchase Specification For Clariflocculator

The document specifies requirements for a bridge mechanism with a scraper to remove settled sludge from the bottom of a clariflocculator. The bridge will span half the diameter of the clariflocculator and have a 1:12 bottom slope. It will be made of MS steel coated with protective paints and have accessories like a weir plate and hand rails. A 415V three-phase motor with IP68 protection will power the mechanism.

Uploaded by

contactdevansh1174
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

SPECIFICATION FOR BRIDGE WITH SCRAPER MECHANISM FOR CLARIFLOCCULATOR

SL NO Parameter Value
1 Quantity N
2 Type End Carriage Driven with PP
roller
3 Objective To scrap settled water
treatment sludge etc
4 Span of bridge Half of Diameter extended to
hold flocculator paddle
5 Launder Inside
6 Diameter of Clariflocculator As per design
7 SWD of Clariflocculator As per design
8 Free Board As per design
9 Bottom slope 1:12
10 MOC of mechanism Complete bridge 1.0 m wide,
Central drum, and scraper
mechanism shall be of MS
material of IS 2062 grade.
All parts submerged in water
shall be provided with zinc rich
epoxy primer of 75 micron thick
coal tar based epoxy paint.
Structure above water level
shall be provided with two coats
red oxide primer and two finish
coat of synthetic enamel.
Squeezers shall be brass or
neoprene rubber.
11 For detail Refer attached specification
from
12 Accessories Weir plate with fixing bolts for 5
mm thick FRP weir plate, hand
rail on bridge of GS pipe. Cover
on motor and gear box.
13 Motor It should be 415 volt three
phase, insulation class B with
IP68 protection.

You might also like