Scribd
Upload
104 views1 page

Sample Purchase Specification Thickener

The document provides specifications for a bridge with a scraper mechanism for a thickener. It lists parameters like quantity, type, objective, span, diameter, and slope. It specifies materials like MS, epoxy primer and paint coatings. Accessories include a weir plate and hand rails. Motor requirements are also defined.

Uploaded by

contactdevansh1174
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
104 views1 page

Sample Purchase Specification Thickener

The document provides specifications for a bridge with a scraper mechanism for a thickener. It lists parameters like quantity, type, objective, span, diameter, and slope. It specifies materials like MS, epoxy primer and paint coatings. Accessories include a weir plate and hand rails. Motor requirements are also defined.

Uploaded by

contactdevansh1174
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

SPECIFICATION FOR BRIDGE WITH SCRAPER MECHANISM FOR THICKENER

SL NO Parameter Value
1 Quantity N
2 Type Centrally driven scraper drive
3 Objective To scrap settled water
treatment sludge etc
4 Span of bridge Across the diameter
5 Diameter of Thickener As per design
6 SWD of Thickener As per design
7 Free Board As per design
8 Bottom slope of sedimentation tank 1:10
9 MOC of mechanism Complete bridge 1.0 m wide,
Central drum, and scraper
mechanism shall be of MS
material of IS 2062 grade.
All parts submerged in water
shall be provided with zinc rich
epoxy primer of 75 micron thick
coal tar based epoxy paint.
Structure above water level
shall be provided with two coats
red oxide primer and two finish
coat of synthetic enamel.
Squeezers shall be brass or
neoprene rubber.
10 For detail Refer attached drawing
11 Accessories Weir plate with fixing bolts for 5
mm thick FRP weir plate, hand
rail on bridge of GS pipe. Cover
on motor and gear box.
12 Motor It should be 415 volt three
phase, insulation class B with
IP68 protection.

You might also like