Scribd
Upload
430 views

Mat 003 Ls-Dyna

This material model is suited for modeling isotropic and kinematic hardening plasticity with optional rate effects. It is available for beam, shell, and solid elements. The model uses two cards to define parameters including material ID, density, modulus of elasticity, Poisson's ratio, yield stress, tangent modulus, hardening parameter, and strain rate parameter. Figure 3.1 illustrates the elastic-plastic behavior with kinematic and isotropic hardening for this material model.

Uploaded by

Andrei Teo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
430 views

Mat 003 Ls-Dyna

This material model is suited for modeling isotropic and kinematic hardening plasticity with optional rate effects. It is available for beam, shell, and solid elements. The model uses two cards to define parameters including material ID, density, modulus of elasticity, Poisson's ratio, yield stress, tangent modulus, hardening parameter, and strain rate parameter. Figure 3.1 illustrates the elastic-plastic behavior with kinematic and isotropic hardening for this material model.

Uploaded by

Andrei Teo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

*MAT_003 *MAT_PLASTIC_KINEMATIC

*MAT_PLASTIC_KINEMATIC

This is Material Type 3. This model is suited to model isotropic and kinematic hardening
plasticity with the option of including rate effects. It is a very cost effective model and is
available for beam (Hughes-Liu and Truss), shell, and solid elements.

Card 1 1 2 3 4 5 6 7 8

Variable MID RO E PR SIGY ETAN BETA

Type A8 F F F F F F

Default none none none none none 0.0 0.0

Card 2

Variable SRC SRP FS VP

Type F F F F

Default not used not used not used 0.0

VARIABLE DESCRIPTION

MID Material identification. A unique number or label not exceeding 8


characters must be specified.

RO Mass density.

E Young’s modulus.

PR Poisson’s ratio.

SIGY Yield stress.

ETAN Tangent modulus, see Figure 3.1.

BETA Hardening parameter, 0 < β ′ < 1 . See comments below.

SRC Strain rate parameter, C, for Cowper Symonds strain rate model, see
below. If zero, rate effects are not considered.

38 (MAT) LS-DYNA Version 971


*MAT_003 *MAT_PLASTIC_KINEMATIC

Figure 3.1. Elastic-plastic behavior with kinematic and isotropic hardening where l0 and l
are undeformed and deformed lengths of uniaxial tension specimen. Et is the
slope of the bilinear stress strain curve.

40 (MAT) LS-DYNA Version 971

You might also like