Scribd
Upload
1K views2 pages

Reset XSCF Lost Password - Sun m4000 - m5000

This document provides steps to reset a lost password for the XSCF on a Fujitsu M5000/M4000 server. It involves connecting to the server's serial port and using the operator panel to authenticate with the default account and no password. Once logged in, the instructions show how to create a new user account, set the password, and assign user privileges.

Uploaded by

Sankar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views2 pages

Reset XSCF Lost Password - Sun m4000 - m5000

This document provides steps to reset a lost password for the XSCF on a Fujitsu M5000/M4000 server. It involves connecting to the server's serial port and using the operator panel to authenticate with the default account and no password. Once logged in, the instructions show how to create a new user account, set the password, and assign user privileges.

Uploaded by

Sankar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

RESET XSCF LOST Password: M5000/M4000

The following procedure is to reset a lost password.

---
1. Connect the administrative console to the serial port using the serial cable that
shipped with the server.
2. Configure the settings on the administrative console. The console should have the
following settings:

• Baud rate: 9600 bps


• Data length: 8 bit
• Parity: None
• Stop: 1 bit
• Flow control: None
• Delay: Except for 0

3. When the login prompt appears, enter default for the login name:

• Default user account: default


• The user privileges are useradm, platadm.
• Default password:

The default password is not input directly on the keyboard. Instead, after the default
user account is input, the mode switch of the operator panel is operated as follows.

• If Locked, change to Service. (Or if Service, change to Locked)


• Press return. Keep the status for more than 5 seconds.
• Change to Locked. (Or change to Service)
• Press return.

This mode switch operation is done within one minute. When one minute is passed, the
authentication timeout occurs.
Sample
login: default
Change the panel mode switch to Service and press return...
(Operation : Locked state -> Service -> Return)
Leave it in that position for at least 5 seconds. Change the panel
mode switch to Locked, and press return...
(Operation : Wait more than 5 seconds -> Service state ->
Locked -> Return)
XSCF>
4.Use the showuser -l command to confirm your current user info.

Sample:

User Name: xxxxx


UID: 100
Status: Enabled
Minimum: 0
Maximum: 99999
Warning: 7
Inactive: -1
Last Change: Mar xx, 20xx
Password Expires: Never
Password Inactive: Never
Account Expires: Never
Privileges: useradm
platadm
fieldeng

5. Create a new user for XSCF

6. Using the commands below, set user account, password and privileges.
XSCF> adduser xxxxx
XSCF> password xxxxxxxx
XSCF> setprivileges xxxxxx

Ex:
XSCF> adduser adminuser
XSCF> password adminuser
New XSCF password: xxxxxxxx
Retype new XSCF password: xxxxxxxx
XSCF> setprivileges adminuser useradm platadm platop

7. You can use the exit command to logout and try your new user account.

8. Done.

You might also like