Scribd
Upload
9K views1 page

128 Sid 211

The document provides diagnostic information for a fault with the sensor supply voltage #2 for an engine control unit. It describes two fault modes - when the voltage is above 5.5V or below 4.5V. The symptoms and possible causes are listed for each fault mode, including incorrect sensor values, low power, and red warning messages. Specific diagnostic actions are provided to check sensor values using PID codes.

Uploaded by

Naing Min Htun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9K views1 page

128 Sid 211

The document provides diagnostic information for a fault with the sensor supply voltage #2 for an engine control unit. It describes two fault modes - when the voltage is above 5.5V or below 4.5V. The symptoms and possible causes are listed for each fault mode, including incorrect sensor values, low power, and red warning messages. Specific diagnostic actions are provided to check sensor values using PID codes.

Uploaded by

Naing Min Htun
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Volvo Guided Diagnostics

Date: Information Type:


11/17/2011 Diagnostics Fault Codes 128: Engine ECU 211: Sensor Supply Voltage #2 (+5V
DC)
Profile:
EXC, EC290B LC (Volvo) [GB] EXC, EC290B LC (Volvo) [GB] EXC, EC290B LC (Volvo) [GB] EXC, EC290B LC (Volvo) [GB]
EXC, EC290B LC (Volvo) [GB]

MID128 Engine ECU;SID211 Sensor Supply Voltage #2 (+5V DC)(128


SID211)
128 SID211

Reference

Fault mode diagnosis

Fault mode Detection conditions:The engine control unit (E-ECU) registers: that the voltage is above
FMI 3 5.5 V (EB17)(EB18)
Symptom: Possible causes:

 Red central warning  Short circuit to higher voltage


 Buzzer sounds one time  Defective sensor
 Error message screen
 Incorrect values from engine's
sensors generated
 Low power

Action 3021 128 PID94


3021 128 PID100
3021 128 PID110
3021 128 PID172

Fault mode Detection conditions:The engine control unit (E-ECU) registers: that the voltage is below
FMI 4 4.5 V (EB17)(EB18)
Symptom: Possible causes:

 Red central warning  Short circuit to lower voltage


 Buzzer sounds one time  Defective sensor
 Error message screen
 Incorrect values from engine's
sensors generated
 Low power

Action 3021 128 PID94


3021 128 PID100
3021 128 PID110
3021 128 PID172

Guided Diagnostics

You might also like