Scribd
Upload
548 views

t5 Steering Angle Basic Settings

The document provides instructions for performing basic settings on a Transporter vehicle model after replacing the steering angle sensor, as the settings cannot be done via the standard diagnostic tester. It involves using the diagnostic tester to zero the steering angle sensor position, enter access codes, and perform settings for the sensor and brake pressure sender. Finally, a test drive is required while monitoring warning lights to complete the basic settings procedure.

Uploaded by

Cristian Sindie
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
548 views

t5 Steering Angle Basic Settings

The document provides instructions for performing basic settings on a Transporter vehicle model after replacing the steering angle sensor, as the settings cannot be done via the standard diagnostic tester. It involves using the diagnostic tester to zero the steering angle sensor position, enter access codes, and perform settings for the sensor and brake pressure sender. Finally, a test drive is required while monitoring warning lights to complete the basic settings procedure.

Uploaded by

Cristian Sindie
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Basic settings for Transporter steering Angle sensor.

Ref. 007/07

The following information refers to Transporter models which, after replacement of the Steering
Angle Sensor, will not accept basic settings via the VAS diagnostic tester.

In the event of a problem carrying out basic settings please use the following procedure;

Note: do not read the fault memory during this procedure

- Switch on the ignition

- Select address code ‘03 brakes electronics’

- Confirm function 06 basic settings, display group 103. Test drive inactive (deactivated). Go
back with arrow button.

- Confirm function 011 check measured values, zero the position of the steering angle, this is
displayed in group 04, move the steering wheel 15° to the left and right; then to 0.0° (max
tolerance. +/- 1 °) if necessary correct by turning the steering wheel. Go back with arrow
button.

- Confirm function 015 access authorisation, coding 2, (login 40168). Go back with arrow
button.

- Enter and confirm function 06 basic settings -> 060 (steering angle sensor). Go back with
arrow button.

- Confirm function 015 access authorisation, coding 2, (login 40168). Go back with arrow
button.

- Enter and confirm function 06 basic settings -> 063 (sensor for lateral acceleration and
wheel speed). Go back with arrow button

-Confirm function 015 access authorisation, coding 2, (login 40168). Go back with arrow
button.

-Enter and confirm function 06 basic settings -> 066 (brake pressure sender). Go back with
arrow button.

-Confirm function 06 basic settings, display group 093. Test drive active (activated).

- Switch off the ignition and start the vehicle, apply the brakes, the ESP lamp flashes. Now
perform the test drive.

Note:
- ABS warning light on
- ESP warning light flashes

continued

Author: Technical Support


Date: 11th June 2007 Contact No: 08450 770077 Option 3 Page 1 of 2
Perform a test drive of max. 50 seconds and at a speed between 15 to 30 km/h. (There must be
no ABS / EDL/ TCS or ESP actuation / intervention during the test drive.)
Drive around a bend at a steering wheel turn of over 90° (possibly several full circles).

The ESP test drive is successfully completed, when the ESP warning goes out.

Author: Technical Support


Date: 11th June 2007 Contact No: 08450 770077 Option 3 Page 2 of 2

You might also like