One day workshop
on
“Power System Grid Operation using Synchrophasor Technology”
December 06, 2019
Power Systems Division (PSD)
Central Power Research Institute
(Govt. of India Society, Ministry of Power)
Prof Sir C V Raman Road, P.B.No: 8066
Sadashivanagar Post Office,
Bengaluru 560 080, Karnataka, India
Web: www.cpri.in
About the Workshop
The Modern power grid is monitored in control centre via SCADA systems, very reliable but slower one. The
system operator who gets experience in different contingencies and unable to hope up with these because of
old equipment, no infrastructure growth and demand is more but generation is less. Also, the main drawback
of the existing SCADA systems are lack of time stamping, lack of visualization and inadequate in monitoring of
power system under dynamic/transient conditions in real time. This has forced operator to look for new
intelligent monitoring sensors and important one for the present scenario is called Phasor Measurement Unit
(PMU) and also called as Synchrophasor. PMUs are enabler for Wide Area Monitoring, Protection and Control
(WAMPAC). Synchrophasor standard defines synchrophasors, frequency, and rate of change of frequency
(ROCOF) measurement under all operating conditions. IEC/IEEE 60255-118-1:2018 specifies methods for
evaluating these measurements and requirements for compliance with the standard under both steadystate
and dynamic conditions. Time tag and synchronization requirements are included. Performance requirements
are confirmed with a reference model. Cyber security issues in Synchrophasor is a major concern for Grid
operation perspective and the same would also be discussed.
The following topics will be covered in the workshop:
• Synchrophasor Technology fundamentals
• Synchrophasor for Power System Grid Operation
• Compliance of Synchrophasor as per IEC/IEEE 60255-118-1:2018
• Deployment of Large Scale of Synchrophasors in Indian Power Grid
• Cyber Security issues in Synchrophasors & Wide Area Monitoring, Protection
and Control (WAMPAC)
• Demo on PMU Calibration System
Who should attend?
The workshop is aimed at Engineers, Managers responsible for the operation and maintenance of
Renewable Energy Systems, Distribution Systems, Transco's, Discoms, Transmission & Distribution
Planners, Consultants, Officers of Power Utilities/Corporations, State Govt./SEBs, Policy makers,
Entrepreneurs, Energy Planners, Renewable Energy Providers, Private Entrepreneurs,
Manufacturers, Research/Academic Institutions and Financial Institutions, etc.
Registration
Private Organisations Rs 5900/- (Inclusive of GST)
State Power Utilities Rs 4,130/- (Inclusive of GST)
Faculty members of Educational Institutions Rs 4,130/- (Inclusive of GST)
Students/Research Scholar of Educational Institutions Rs 2,950/- (Inclusive of GST)
Registration form, a part of this brochure, complete in all respect shall be sent to the workshop
Coordinator along with the registration fee in the form of crossed DD drawn in favour of Accounts
Officer, CPRI, payable at Bangalore.
Participants from international may transfer the fee via Swift code No.: SBININBB425, SBI A/C No.
10270577483, and participant from National may transfer fee to SBI A/C
No.10356553310, IFSC code: SBIN0002215. Beneficiary Name: SBI, IISc Branch, Bangalore under
intimation to the workshop coordinators.
Kindly use separate form for each participant, Downloaded/ Photo copies of Registration form are
acceptable.
The Registration fee includes kit, workshop material-soft copy, tea/coffee with snacks and
working lunch for one day.
Travel & Accommodation
Bangalore is well connected by Road, Rail and Air.
Participants have to make their own travel arrangements.
Guest house accommodation on twin share basis can be provided on chargeable basis subject to
availability.
Power Systems Division (PSD)
Power Systems Division with its state-of-the-art facilities and latest software tools offers a wide range
of power system simulation services, including real time performance analysis of various types of
controllers such as FACTS, HVDC, SVC and protection relays. It has been conducting power system studies
for the past two decades for its own needs and at the request of utilities and manufacturers. To carry out
such studies the division possesses Real Time Digital Simulator (RTDS), RT Lab and various Power
System Analysis Software Packages. Power Systems Division has carried out for the first time in the
country the pilot project on “Protection system study and Protection audit” of selected DTL
transmission system. Furthermore the Division is accredited by ISO: 9001-2015.
The Relay Testing Laboratory (RTL) is equipped with sophisticated Computerized Relay
testing systems for testing of Protection relay for all its characteristics/functions meeting its accuracy
requirements as per IS:3231 series and IEC:60255 series of standards. The
laboratory conforms to ISO/IEC 17025-2017 requirements. Field-testing of protection relays is also
carried out for major power stations and utilities and also undertakes pre-dispatch Third Party
Inspection (TPI) on Relay and Control panel.
Central Power Research Institute, Bangalore has established country’s first Phasor
Measurement Unit (PMU) test facility. Fluke make 6135A/PMUCAL Phasor Measurement Unit
Calibration system is a automated system and has traceable solution for PMU testing and Calibration.
It's a unique facility for carrying out Validation/Evaluation of PMU both M-class and P-Class steady
state and Dynamic conditions as per IEEE C37.118.1-2011, IEEE C37.118.1a-2014, IEEE
C37.242.2013, IEEE Synchrophasor Measurement Test suite Specification-Version 2-2015 and
IEC/IEEE 60255.118.1:2018.
6135A/PMUCAL at a Glance
The 6135A/PMUCAL system enables you to:
* Calibrate and test a PMU from a client PC, either at the site of the test system or remotely
over the Internet
* Quickly set up a PMU test
* Speed through automated calibration procedures
* Provide the required static and dynamic voltage and current conditions that occur in a
power distribution grid specified by the standard
* Apply those signals to a phasor measurement unit
* Capture the PMU's reported results
* Compare those results with the original stimulus
* Evaluate against the thresholds defined in IEEE Std C37.118.1a™-2014 &
IEC/IEEE 60255-118-1:2018
* Create test reports, graphs and calibration certificates that can be readily printed or
shared electronically
CPRI'S Profile
Central Power Research Institute (CPRI) set up in 1960 by the Government of India, functions as a
National organization for applied research in power sector and also serves as an Independent
Laboratory for testing and certification of power equipment. CPRI is a member of STI (Short Circuit
Testing Liaison) of Europe and is accredited by M/s ASTA of UK. CPRI also provides consultancy
services on various facets of power sector. CPRI has expertise in the area of Simulation, Diagnostics,
System Analysis and Testing. CPRI laboratories have modern equipment needed for Power system
simulation, Short circuit testing, Diagnostics of equipment, Materials engineering, Seismic
qualification etc. CPRI has experienced faculty in different subjects concerned to power sector with
practical experience in their areas of interest, as well as extensive experience in presenting
courses/seminars.
Over the period, CPRI officers have gained lot of practical knowledge concerning to testing and
operational problems of the industry. CPRI is a leading provider of Training and Continuing Education
to Utilities, PSUs across the country for the past 50 years. CPRI is continually setting new standards
in training and continuing education from basic theoretical information to practical hands-on electrical
equipment training. CPRI courses have made substantial impact on the level of training and education
to India's electricity utilities, manufacturing companies, transmission and distribution companies. By
upgrading the occupational skill of technical workers, CPRI training courses have improved the career
path of many electrical personnel as well as contributed to an improvement in electricity efficiency,
plant productivity, electrical system reliability an overall competitiveness of Indian industry.
Programme Coordinator
Shri Kaliappan Perumal, B.Tech., M.E., (Ph.D). He has 25 years of experience with CPRI
working in the field of Power System Protection, Synchrophasor, Wide Area Monitoring, Protection
and Control (WAMPAC) and Smart Grid Technology and Applications. His areas of interests are
Adaptive Relaying, Computer Relaying, Protection issues in Distributed Generation, Validation of
Phasor Measurement Unit, Synchrophasor for Power system Protection and Control applications,
Internet of Things with Renewable Energy, Internet of Things with Smart Grid, Cyber Physical System
Security for the Smart Grid. Presently he is holding the Post of Joint Director with Power Systems
Division of CPRI, Bangalore. He is an IEEE member as well as member in IEEE PES Bangalore
section and he is also pursuing his Ph.D at National Institute of Technology (NIT), Tiruchirappalli.
Mobile: +91 94491 49924, Email: [email protected]
REGISTRATION FORM
CENTRAL POWER RESEARCH INSTITUTE
PROF. SIR. C.V. RAMAN ROAD, PO BOX 8066,
SADASHIVANAGAR PO, BANGALORE 560 080
Phone: +91(0)80 2207 2449
One day workshop
on
“Power System Grid Operation using Synchrophasor Technology”
December 06, 2019
Mr. Ms. Mrs. Dr. Prof. Others (please specify)___________________________________________
Full Name of the Participant
_______________________________________________________________________________
Designation__________________________________ Nationality___________________________
Full address of Organisation
_______________________________________________________________________________
(for correspondence)
_______________________________________________________________________________
Country:____________________ZIP/PIN Code:_________________________________________
Phone/Fax Nos.: (Please Mention Country & STD Code)
Office:_________________________________Res(Optional):_____________________________
Fax:___________________________________Mobile/Cell:_______________________________
E-mail:__________________________________________________________________________
Enclosed is a Demand Draft No:___________dated________for Rs._________ drawn on
_____________________________________bank towards delegate fee drawn in
favour of “Accounts Officer, CPRI” payable at “Bangalore.”
Signature:
(participant or nominating authority)
Name:
Designation:
Date:
Note: Kindly mention your Name, Name of the Company and Name of the workshop behind the
Demand Draft
CANCELLATIONS & SUBSTITUTIONS:
Registration without payment does not confirm the reservation for the event. Request for cancellations must
be received in writing, more than 7 working days before the workshop to get refund. However, Rs.1000/-per
delegate will be deducted as handling charges. If the fee has been paid in full, substitutions can be made with
prior intimation with no extra cost. In case this event is cancelled, full refund will be made. CPRI reserves the
right to postpone or cancel this event.
CPRI reserves the right to accept/reject the delegate
Kindly use separate form for each participant, downloaded/photocopies of this registration form is acceptable.
