Scribd
Upload
50 views

Pulse Width Modulation: Figure 1 Matlab Simulink

The document discusses pulse width modulation techniques used for controlling AC output voltage of power converters. It describes high switching frequency modulation using phase shift in carrier modulation and multi-carrier modulation schemes. The document also discusses phase shift carrier modulation and provides figures of a Simulink model and output of a single phase multilevel inverter as an example.

Uploaded by

nasiruddin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views

Pulse Width Modulation: Figure 1 Matlab Simulink

The document discusses pulse width modulation techniques used for controlling AC output voltage of power converters. It describes high switching frequency modulation using phase shift in carrier modulation and multi-carrier modulation schemes. The document also discusses phase shift carrier modulation and provides figures of a Simulink model and output of a single phase multilevel inverter as an example.

Uploaded by

nasiruddin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Pulse width Modulation.

The pulse width modulation (PWM) is widely used for controlling the AC output voltage of a
power converter. The targeted (reference) AC output voltage is obtained by varying the duty
cycle of switching devices. The PWM schemes are designed to reduce the output voltage
harmonic distortion and increase the magnitude of the output voltage at a given switching
frequency.
In Pulse width modulation, I use high switching frequency Modulation in which I use phase
shift in carrier Modulation

Pulse Width Modulation


Scheme

High Switching Frequency


Modulation

Phase Shift Carrier


Modulation

The carrier modulation schemes are extended to the multilevel converters, where multiple
triangular carrier signals are compared with a phase modulation signal to generate the gating
signals. This approach is referred to as a multi-carrier modulation scheme

Figure 1 Matlab Simulink


In PSC-PWM, all triangular signals have the same frequency and peak-to-peak amplitude, but
there is a phase-shift between the adjacent triangular signals.

◦
Φc = 360
N
By using 6 Submodule. 3 submodule for upper arm and 3 submodule for lower arm the angle
between adjacent triangular Signals is 60 degree which I compare it with Reference signal
that is gated signal due to which the ideal switch become ON and OFF properly.

The Internal structure of each sub module is compose of two ideal switches and one Battery
source.

Figure 2: Sub-Module structure

The DC-bus voltage Vdc=9kv which is equally distributed between the submodules in each
arm, and its value is equal to

E=Vdc/N =9000/3=3000v per submodule


Comparing of Refrence signal with multi carrier signal and its one output

Figure 3 carrier wave shifting and reference signal

Simulink model of single phase multilevel inverter

Figure 4 Single phase multilevel inverte


Output of the single phase multilevel inverter

You might also like