Scribd
Upload
64 views

Configuring Ethernet Card: Information Sheet 2.2-4

This document provides instructions for installing both wired and wireless network interface cards (NICs) in a computer. It outlines the steps to install each type of NIC which include removing the blank from the computer case, aligning the NIC with an expansion slot on the motherboard, pressing down on the NIC until fully seated, and securing it with a screw. The document also identifies the learning objectives which are to install wireless and wired NICs and assign the proper IP address.

Uploaded by

Marj Demesa Palo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
64 views

Configuring Ethernet Card: Information Sheet 2.2-4

This document provides instructions for installing both wired and wireless network interface cards (NICs) in a computer. It outlines the steps to install each type of NIC which include removing the blank from the computer case, aligning the NIC with an expansion slot on the motherboard, pressing down on the NIC until fully seated, and securing it with a screw. The document also identifies the learning objectives which are to install wireless and wired NICs and assign the proper IP address.

Uploaded by

Marj Demesa Palo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

INFORMATION SHEET 2.

2-4

Configuring Ethernet Card

LEARNING OBJECTIVES:

After reading this INFORMATION SHEET, STUDENT(S) MUST be able to:

1. Install wireless NIC


2. Install wired Ethernet card
3. Assign proper IP address

INTRODUCTION

A network interface card (NIC) enables a


computer to connect to a network. NICs use
peripheral component interface (PCI) and PCIe
expansion slots on the motherboard, as shown in

Procedures
1. Remove the blank from the case where the
new card will be installed so that the port can
be accessed.
2. Align the NIC with the appropriate expansion
slot on the motherboard.
3. Press down gently on the NIC until the card is fully seated.
4. Secure the NIC PC mounting bracket to the case with the appropriate
screw.

CBLMs on Computer Document No.


System Servicing NC II Version 1.2.2019
Developed by
Setup Computer
Ismael Manic
Network
Balana Revision # 01
INSTALL THE WIRELESS NIC

A wireless NIC, as shown in figure, enables a computer to connect to a wireless


network. Wireless NICs use PCI and PCIe expansion slots on the motherboard.
Some wireless NICs are installed externally with a USB connector.
Follow these steps for wireless NIC installation:
1. Align the wireless NIC with the appropriate
expansion slot on the motherboard.
2. Press down gently on the wireless NIC until
the card is fully seated.
3. Secure the wireless NIC PC mounting bracket
to the case with the appropriate screw.

CBLMs on Computer Document No.


System Servicing NC II Version 1.2.2019
Developed by
Setup Computer
Ismael Manic
Network
Balana Revision # 01

You might also like