Cat Prime Application Grease
Cat Prime Application Grease
Corrosion Protection—Resists oxidation and protects metal against rust. Will not
corrode or damage steel, copper bearing alloys or conventional seal material.
Cat® Prime Application Grease
Grease Selection Guide
Cat Extreme Application Grease 1 Cat Extreme Application Grease - Desert Cat Prime Application Grease Cat Ball Bearing Grease
NLGI 1 NLGI 2 NLGI 2 NLGI 2
(-20 to 140ºC / -4 to 284ºF) (-10º to 140ºC / +14º to 284ºF) (-20 to 140ºC / -4 to 284ºF) (-20º to 160ºC / -4º to 320ºF)
With 5% Moly With 5% Moly With 3% Moly Without Moly
Cat Extreme Application Grease 2 Cat Extreme Application Grease - Arctic Cat Utility Grease
NLGI 2 NLGI 0.5 NLGI 2
(-15 to 140ºC / +5 to 284ºF) -50º to 130ºC / -58º to 266ºF) (-20 to 140ºC / -4 to 284ºF)
With 5% Moly With 5% Moly Without Moly
Working High Load & Med Load & Low Load & Low Load &
High Temp Low Temp
Environment High Speed Med Speed Low Speed High Speed
Typical Properties
NLGI 2 Recommended Use
Color Gray Black Cat Prime Application Grease is
Molybdenum Disulfide, % 3 recommended for grease fittings and
lubrication points in medium-load,
Operating Temperature Range, °C -20 to +140
medium-speed applications where
Operating Temperature Range, °F -4 to +284 operating temperatures range from
Base Oil Type Mineral -20°C to +140 °C (-4°F to +284 °F).
ASTM D445 Base Oil Viscosity 40°C, mm²/s 320
Thickener Type Lithium Complex
Health and Safety
ASTM D2265 Dropping point, °C 260 For information on proper use for health,
safety and environment, please refer to
ASTM D217 Penetration, worked 60, mm/10 280
the Material Safety Data Sheet (MSDS).
ASTM D1831 Roll stability, penetration change, mm/10 -3 Read and understand the MSDS before
ASTM D2266 4 Ball wear, scar diameter, mm 0.47 using this product. Always observe good
ASTM D2596 4 Ball weld load, kg 400 hygiene measures. For a copy of the
MSDS, contact us or visit the web at
ASTM D1743 Rust prevention Pass
www.catmsds.com.
ASTM D4048 Copper corrosion 1A
ASTM D1264 Water wash-out, 79°C, mass % 6
The values shown are typical values and should not be used as quality control parameters to either accept or reject product.
Specifications are subject to change without notice.
PEHJ0404
www.cat.com