Scribd
Upload
374 views1 page

How To Change The Eld Frequency (Held-2009S) : "MODE" " " "PD - 0"

To change the ELD frequency from 60Hz to 50Hz: 1. Access the programming mode by pressing buttons to display "pd-0". 2. Enter the programming code "rc-000" by pressing buttons in a specific sequence. 3. Navigate to "Fr.-60" and change it to "Fr.-50" by pressing buttons, then press and hold "PRG" to save. 4. Verify the frequency is now set to "Fr.-50" by repeating the first three steps.

Uploaded by

Rachmad Maulana Ramadhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
374 views1 page

How To Change The Eld Frequency (Held-2009S) : "MODE" " " "PD - 0"

To change the ELD frequency from 60Hz to 50Hz: 1. Access the programming mode by pressing buttons to display "pd-0". 2. Enter the programming code "rc-000" by pressing buttons in a specific sequence. 3. Navigate to "Fr.-60" and change it to "Fr.-50" by pressing buttons, then press and hold "PRG" to save. 4. Verify the frequency is now set to "Fr.-50" by repeating the first three steps.

Uploaded by

Rachmad Maulana Ramadhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

HOW TO CHANGE THE ELD FREQUENCY (HELD-2009S)

1. Push “MODE” button à Push “▲” buttons until “pd – 0” is displayed.

2. In this status (“pd - 0”), Push “MODE” button (“0” will be blinked)
- In this status, push “▲” buttons 5times(until “5” displayed) à push “◀” à
push “▲” button 6times(until “6” displayed) à push “◀” à push “▲” buttons (“1” displayed) à push “ENTER” button
à Result : “rc-000”

3. In this status (“rc-000”), Push “▲” buttons until “Fr. – 60” is displayed.

4. In this status (“Fr. - 60”), Push “MODE” button à push “▼” button (change “Fr.-60” to “Fr.-50”) à push “ENTER” à “Fr - 50”
displayed (the dot next to “Fr” will be removed) à keep pushing “PRG” button for about 3seconds à “Fr. - 50” displayed (the dot
next to “Fr” will appear again)

5. In this status (“Fr. - 50”) à push the “MODE” button à “Fr” will blink à push “RST” button à “C - - 0” displayed à turn off the
ELD power

*** after completing all the procedure, you must check whether the frequency is set a “Fr. - 50”
normally by doing 1~3 procedure again.

You might also like