Scribd
Upload
963 views6 pages

Closed Circuit Television (CCTV) Camera - Site Test

This document describes tests to confirm the operational status of a closed circuit television (CCTV) camera. The tests include: 1) Verifying the installation meets plans and specifications on-site; 2) Testing the lowering system, power, and camera functions locally; 3) Confirming communication between the camera and traffic management center; and 4) Remotely operating and diagnosing the camera via traffic management software.

Uploaded by

Muhammad Yusri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
963 views6 pages

Closed Circuit Television (CCTV) Camera - Site Test

This document describes tests to confirm the operational status of a closed circuit television (CCTV) camera. The tests include: 1) Verifying the installation meets plans and specifications on-site; 2) Testing the lowering system, power, and camera functions locally; 3) Confirming communication between the camera and traffic management center; and 4) Remotely operating and diagnosing the camera via traffic management software.

Uploaded by

Muhammad Yusri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

Rev 3; 2/10/17

Closed Circuit Television (CCTV) Camera – Site Test


This test will confirm that the CCTV equipment at the site is fully operational, per manufacturer’s
specifications, prior to network connectivity.
CCTV: General Information
CCTV: General Information

Project Number: Project Name:

Project Stationing: Date of Test:

Device Name: Manufacturer:

Serial #: Model #:

Username (If Password (If


Required): Required):

Communication IP
Method: Address:

Subnet Mask: Inspector:

CCTV: General Requirements


Requirement Pass Fail Notes
Verify location of device installation is as per the plans.
Structure offset from edge of travel lane: ___________
Latitude:_____________ Longitude:_______________

Verify all installed devices and equipment (including


components inside of cabinets) match the approved
shop drawings and catalog cuts.

CCTV Camera – Site Test Page 1 of 3


Rev 3; 2/10/17

CCTV: Lowering System


CCTV: Lowering System
Requirement Pass Fail Notes
Verify the camera lowering system functions by
completely lowering and raising the CCTV, using both
powered lowering device and manual winch 3 times each.

Verify that CCTV is stable and locked at the top of the


CCTV Lowering System by visual inspection.

Verify that network cable has proper strain relief within


pole and is not being damaged by movement of pulleys
and support cable.

CCTV: AC Power – Device Specific


Requirement Pass Fail Notes

Verify voltage in CCTV load center is within +/- 5% of


120 VAC or 240 VAC.

Verify that lightning surge protection is installed at both


ends of CCTV power over Ethernet cables.

Verify that the device manufacturer’s recommended


power/communication cable is being used and is of
adequate length.

For documentation purposes, record the Ethernet Injector Not a pass Record wattage:
(POEI) power consumption from the AC Mains. / fail test
V: Operations
CCTV: Operations
Requirement Pass Fail Notes
Visually verify quality of video in day mode. The video
will be full motion at the required resolution, without any
noise interference or distortion.

Verify the camera pans 360+ degrees to left and right.

Verify the camera tilt range is from 20 degrees above


horizon to 90 degrees below horizon.

Verify the camera has 30x optical zoom and 12x digital
zoom.

CCTV Camera – Site Test Page 2 of 3


Rev 3; 2/10/17

CCTV: Operations
Requirement Pass Fail Notes

Verify manual and auto focus capability.

Verify auto iris capability.

Verify manual iris operation by opening and closing to


display the adjustment to light levels.

Overall CCTV Site Test:  Pass  Fail

Inspector Name: ______________ Organization: ______________ Signature: _____________

Witness Name: ______________ Organization: ______________ Signature: _____________

Date: ________________

CCTV Camera – Site Test Page 3 of 3


Rev 3; 2/10/17

CCTV Camera – Communications & Systems Test


This test will confirm that the installed equipment is fully operational utilizing New Hampshire’s
Advanced Transportation Management System (ATMS) at the NHDOT TMC.
CCTV: General Information
CCTV: General Information

Project Number: Project Name:

Project Stationing: Date of Test:

Device Name: Manufacturer:

Serial #: Model #:

Username (If Password (If


Required): Required):

Communication IP
Method: Address:

Subnet Mask: Inspector:


CCTV: Prerequisites
CCTV: Prerequisites*
Requirement Pass Fail Notes
Contractor has coordinated with the TMC, and has
established connectivity to the camera from the TMC.

Contractor has verified all device components are


configured with supplied IP's, VLANs, configurations, and
interface login credentials, and has properly labeled all
ports in device web interfaces. (ITS Spec 3.5)

Contractor must be ready, with all necessary parties and


preparation, to start the testing at the designated start time.
*-Failure to meet any of the prerequisite requirements shall be grounds for immediate testing termination

CCTV Camera – Communications & Systems Test Page 1 of 4


Rev 3; 2/10/17

CCTV: Communications
CCTV: Communications
Requirement Pass Fail Notes
If wireless communications is utilized, document the signal
strength. ____________dB

Verify communications to the CCTV (Ping).

Verify device status appears on New Hampshire’s ATMS.

Generate a manual communications failure at the CCTV


camera cabinet, and verify both ATMS and manufacturer
software display the error. Verify the CCTV responds after
communications have been restored.

Verify ATMS regains communication to the CCTV after


power has been disconnected in the field for 2 minutes
then restored.
CCTV: Central Control
CCTV: Central Control
Requirement Pass Fail Notes

Perform a full diagnostic scan in ATMS and manufacturer


software, and confirm no errors shown.

Disconnect power to the device, and verify a power supply


error is displayed in ATMS and/or manufacturer software.
Verify the error no longer exists after power is restored.

Open the cabinet door and verify an intrusion alarm is


displayed in ATMS and/or manufacturer software.

Visually verify quality of video in day mode. The video will


be full motion at the required resolution, without any noise
interference or distortion.

Pan Camera 360+ degrees to left and right.

Tilt camera down through full range of motion and then


back to original position.

Zoom camera in fully to selected location within the field of


view then zoom completely out.

Verify manual and auto focus capability.

Verify auto iris capability.

CCTV Camera – Communications & Systems Test Page 2 of 4


Rev 3; 2/10/17

CCTV: Central Control


Requirement Pass Fail Notes

Verify manual iris operation by opening and closing the


iris.

Nighttime - Pan Camera 360+ degrees to left and right.

Nighttime - Tilt camera down through full range of motion


and then back to original position.

Nighttime - Zoom camera in fully to selected location within


the field of view then zoom completely out.

Nighttime - Open and close the iris to display the


adjustment to light levels and transition from color to black
and white mode.

Nighttime - Visually verify quality of video during the above


nighttime tests.

Log into all site device component web interfaces. Verify


no errors are reported, and web interfaces display all
information needed for remote monitoring of device status.
Verify all ports are properly addressed and labeled in
interfaces.

Overall CCTV Systems Test:  Pass  Fail

Inspector Name: ______________ Organization: ______________ Signature: _____________

Witness Name: ______________ Organization: ______________ Signature: _____________

Date: _______________

CCTV Camera – Communications & Systems Test Page 3 of 4

You might also like