Scribd
Upload
52 views1 page

Eng CD K2

This document provides specifications for a custom cross-hole nut used to mount brackets and poles to the Ericsson sxk125 0245/1 pole. The nut is made of stainless steel 304, has a cylindrical height of 20mm±0.05mm and diameter of 19mm±0.05mm, with a center M10×1.5 threaded hole and upper and lower slots that are 2mm±0.02mm wide and 1.5mm±0.02mm deep at a 0-10 degree angle, with the upper and lower round faces requiring chamfering.

Uploaded by

Peng Hao
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
52 views1 page

Eng CD K2

This document provides specifications for a custom cross-hole nut used to mount brackets and poles to the Ericsson sxk125 0245/1 pole. The nut is made of stainless steel 304, has a cylindrical height of 20mm±0.05mm and diameter of 19mm±0.05mm, with a center M10×1.5 threaded hole and upper and lower slots that are 2mm±0.02mm wide and 1.5mm±0.02mm deep at a 0-10 degree angle, with the upper and lower round faces requiring chamfering.

Uploaded by

Peng Hao
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Cross-hole nut, alias hammer nut or hammer nut, used for brackets

and poles, is a standard accessory material. This custom cross-hole

nut is mainly used for the Ericsson sxk125 0245/1 pole.

Size specification

Cylinder height 20mm±0.05mm

Cylindrical diameter 19mm±0.05mm

Center transverse hole thread M10×1.5 Standard thread

Upper and lower slot width 2mm±0.02mm

Slot depth on both sides 1.5mm±0.02mm

Cross-radius angle of the upper and


0～10 度
lower slots

Material stainless steel 304

The upper and lower round faces


other instructions
need to be chamfered

You might also like