Scribd
Upload
404 views

Project Proposal

The document is a project proposal for an automatic door opener using an Arduino and PIR sensor. It introduces the project which uses a PIR (passive infrared) motion sensor to detect when someone approaches the door and triggers the Arduino to open the door. It then describes how PIR sensors work by detecting changes in infrared heat signatures to detect motion. It includes a block diagram of the system with the PIR sensor detecting motion and sending a signal to the Arduino which controls the opening and closing of the door.

Uploaded by

AdeeKhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
404 views

Project Proposal

The document is a project proposal for an automatic door opener using an Arduino and PIR sensor. It introduces the project which uses a PIR (passive infrared) motion sensor to detect when someone approaches the door and triggers the Arduino to open the door. It then describes how PIR sensors work by detecting changes in infrared heat signatures to detect motion. It includes a block diagram of the system with the PIR sensor detecting motion and sending a signal to the Arduino which controls the opening and closing of the door.

Uploaded by

AdeeKhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

PRESTON UNIVERSITY KOHAT CAMPUS

PROJECT PROPOSAL

AUTOMATIC DOOR OPENER USING ARDUINO AND PIR SENSOR

SUBMITTED BY

MUHAMMAD ADEEL

B-TECH (ELECTRICAL) 10TH SEMESTER

SUBMITTED TO

SIR ASAD

REGISTRATION NO.

21P2-315001

DATE

24 MARCH 2019

Student Signature
INTRODUCTION

You must have seen automatic door openers in shopping malls and other commercial
buildings. They open the door when someone comes near the entrance and close it
after sometime. A number of technologies are available to make such kinds of systems
like PIR sensors, Radar sensors, Laser sensors, Infrared sensors, etc. In this arduino
based project, we have tried to replicate the same system by using a PIR sensor.

It uses a motion-detecting sensor (PIR sensor) to open or close the door


which detects the infrared energy omitted from human's body. When someone comes
in front of the door, the infrared energy detected by the sensor changes and it triggers
the sensor to open the door whenever someone approaches the door. The signal is
further sent to arduino uno that controls the door.

PIR Sensor

PIR sensor detects any change in heat, and whenever it detects any change, its output
PIN becomes HIGH. They are also referred as Pyroelectric or IR motion sensors.
Here we should note that every object emits some amount of infrared when heated.
Human also emits infrared because of body heat. PIR sensors can detect small amount
of variation in infrared. Whenever an object passes through the sensor range, it
produces infrared because of the friction between air and object, and get caught by PIR.

The main component of PIR sensor is Pyroelectric sensor shown in figure (rectangular
crystal behind the plastic cap). Along with BISS0001 ("Micro Power PIR Motion Detector
IC"), some resistors, capacitors and other components used to build PIR sensor.
BISS0001 IC take the input from sensor and does processing to make the output pin
HIGH or LOW accordingly.
Pyroelectric sensor divide in two halves, when there is no motion, both halves remain in
same state, means both senses the same level of infrared. As soon as somebody enters
in first half, the infrared level of one half becomes greater than other, and this causes
PIRs to react and makes the output pin high.

Pyroelectric sensor is covered by a plastic cap, which has array of many Fresnel Lens
inside. These lenses are curved in such a manner so that sensor can cover a wide range.

BLOCK DIAGRAM

Motion Based Automatic Door Opener

You might also like