Scribd
Upload
2K views4 pages

Project Proposal: Digital Stopwatch

This project proposal outlines a digital stopwatch circuit that uses a 555 timer IC and two common cathode seven segment displays to indicate elapsed time in hours, minutes, and seconds without a microcontroller. The required components are listed and include ICs, resistors, capacitors, displays, switches, and a power source. A diagram shows how the components connect, with the 555 timer creating a 1 second delay that is fed to the seven segment decoders to increment the displays and indicate the passage of time. Buttons allow for starting, stopping, and resetting the stopwatch.

Uploaded by

Raheem Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
2K views4 pages

Project Proposal: Digital Stopwatch

This project proposal outlines a digital stopwatch circuit that uses a 555 timer IC and two common cathode seven segment displays to indicate elapsed time in hours, minutes, and seconds without a microcontroller. The required components are listed and include ICs, resistors, capacitors, displays, switches, and a power source. A diagram shows how the components connect, with the 555 timer creating a 1 second delay that is fed to the seven segment decoders to increment the displays and indicate the passage of time. Buttons allow for starting, stopping, and resetting the stopwatch.

Uploaded by

Raheem Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Project Proposal

Project:
Digital Stopwatch
Submitted To:

Submitted By:
Raheem Ahmad (70067919)
3rd Semester
BSCS

DEPARTMENT OF CS&IT

Digital Stopwatch

Introduction:
Often we need stopwatch to differentiate the time of two events. Here in this
tutorial we are going to design a simple digital stopwatch circuit, without using any
microcontroller.
Required Components

• IC 4033 - 2 • On/off switch -1


• 555 timer IC -1 • Push button -1
• Common Cathode 7 Segment Display • Bread board -1
-2 • 9 Volt Battery -1
• 150 Ohm -1 • Battery Connector -1
• 100K resistor -1 • LED -1
• 33K resistor -1 • Voltage Regulator 7805 -1
• 56K resistor -1 • Connecting wires
• 10uF capacitor -1
Diagram:

Digital Stopwatch Circuit Diagram and Explanation:


In this circuit we have used a 555 timer IC based Astable multi-vibrator which
is for creating 1 second delay. And two common cathode seven segment decoder
IC’s namely CD4033. The output of Astable multi-vibrator is directly applied to
seven segment decoder IC’s (U4) Clock pin (1) and carry output pin(5) of U4 IC
is directly connected to clock pin (1) of second seven segment decoder(U3). And
two seven segment are connected with these decoder (U3 and U4). Its
connections are shown in stopwatch circuit diagram given below. One push
button is used to stop /start the stopwatch and one push button is used to reset the
stopwatch. A 5 volt voltage regulator is used for providing 5 volt to whole
circuit. And a 9 volt battery is used for powering the circuit. Rest of connections
are shown in the circuit diagram.
The END

You might also like