Scribd
Upload
168 views16 pages

Intelligent Traffic Control System For Smart Ambulance

This document describes an intelligent ambulance project that uses RF modules and Arduino boards to automatically change traffic signals to green when an ambulance approaches. The project uses an Arduino Mega board as the control system at the traffic poles to receive RF signals from an Arduino UNO board in the ambulance. When the ambulance activates a push button, its RF module transmits a signal that is received by the traffic pole's RF module. This triggers the Arduino Mega to change the traffic signals to green in the direction of the ambulance to allow it to pass through the intersection without delay.

Uploaded by

Shivendu Pandey
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
168 views16 pages

Intelligent Traffic Control System For Smart Ambulance

This document describes an intelligent ambulance project that uses RF modules and Arduino boards to automatically change traffic signals to green when an ambulance approaches. The project uses an Arduino Mega board as the control system at the traffic poles to receive RF signals from an Arduino UNO board in the ambulance. When the ambulance activates a push button, its RF module transmits a signal that is received by the traffic pole's RF module. This triggers the Arduino Mega to change the traffic signals to green in the direction of the ambulance to allow it to pass through the intersection without delay.

Uploaded by

Shivendu Pandey
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 16

Akshay Kumar

Anurag Triphati
Mr.Yashwant Mohan Sir
Ayush Kr. Prajapati
(HOD of EN/EC Department)
Sudhanshu Kr. Singh
INTRODUCTION
Block Diagram of Project
Equipments :-
 Arduino UNO Board
 Arduino MEGA Board
 RF Module – 433MHz (TX and RX)
 LCD Display- 16*2
 LED Bulb
 Resistance
 Potentiometer
 Push Button Switch
SUMMARY
 The main aim of this project is developing an intelligent
ambulance which will reach the hospitals without any
problem in heavy traffics.

 According to this project if any ambulance comes near


when the ambulance at emergency comes to any traffic
post the traffic signals automatically stop the signals and
give green signal for this ambulance.
North Direction West Direction

South Direction East Direction

Traffic Pole A Traffic Pole B Traffic Pole C Traffic Pole D

Control System
(Arduino Mega Board)

LCD Display Communication


RF Module RX
North Direction West Direction
South Direction East Direction

Push Push Push Push


Button Button Button Button

Control System
(Arduino UNO Board)

Communication RF Module TX
Timer
Features of RF Module:

 Receiver frequency 433MHz


 Receiver supply current 3.5mA
 Low power consumption
 Receiver operating voltage 5v
 Transmitter frequency range 433.92MHz
 Transmitter supply voltage 3v~6v
 Transmitter output power 4v~12v

You might also like