Scribd
Upload
437 views1 page

V-Wac™ Gauge: Quickly Determines If Fillet Welds Meet NRC Visual Weld Acceptance Criteria For Structural Weldments

V-WAC™ GAUGE

Uploaded by

Lucio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
437 views1 page

V-Wac™ Gauge: Quickly Determines If Fillet Welds Meet NRC Visual Weld Acceptance Criteria For Structural Weldments

V-WAC™ GAUGE

Uploaded by

Lucio
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

V-WAC™ GAUGE

Quickly determines if fillet welds meet NRC


Visual Weld Acceptance Criteria for
Structural Weldments
The V-WAC™ Gage easily and quickly checks the four essential measurements required for compliance with the NRC Visual Weld
Acceptance Criteria. Checks undercut depth, porosity comparison, amount of porosity per linear inch and crown height.
The V-WAC™ Gage can be purchased separately or as part of a complete set of seven Fillet Weld Gaguges that determine if your
welds conform to specifications (See Page 7).

CHECKS UNDERCUT CHECKS AMOUNT


DEPTH OF POROSITY PER
LINEAR INCH

CHECKS POROSITY
COMPARISON
CHECKS CROWN
HEIGHT

Features of the V-WAC™ Gage


ACCURATE
Undercut depth or crown height scale can be
read to 1/32 inch.
Porosity comparison of 1/8 inch and 1/16 inch.
Linear gauge in 1/16 inch increments.

EASY TO USE
Pointer is easy to set and a locking screw holds it
in position for later reference.
Figures and increments are etched into surface.
They are easy to read and will not rub off.

FAST
All four required measurements are made with a
single gauge.

STURDY
Gauge is made of stainless steel.

HANDY
Gauge is 1¼ inches by 4 inches, and can be
easily carried in your pocket. Part No. Description
WG--5 Gauge with 1/64" Tolerance
WG-5-7 Gauge with WTPS Gauge and Block
WG-5-8 Gauge Set
WG-5-7-8 Gauge Set with WTPS Gauge and Block
WG-5M Metric Gauge with 1/64" Tolerance
© June 2000
www.newmantools.com tel 1-800-465-1384 fax 1-800-605-2442 page 5

You might also like