Scribd
Upload
36 views3 pages

Ahmad Mustafa BPSD24: Project Design Aginst Torsion Designer ACI 2005 Date Detail Designation

This document provides the design parameters and calculations for torsional reinforcement of beam BPSD24. The beam has a width of 240mm, height of 600mm, and bar diameter of 560mm. It was designed according to ACI 2005 standards to resist a torsional load of 12 kN-m and shear load of 66 kN. The calculations show that the designed longitudinal and shear reinforcement is adequate to resist the applied torsion and shear stresses.

Uploaded by

Bilal Al-Muhtaseb
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
36 views3 pages

Ahmad Mustafa BPSD24: Project Design Aginst Torsion Designer ACI 2005 Date Detail Designation

This document provides the design parameters and calculations for torsional reinforcement of beam BPSD24. The beam has a width of 240mm, height of 600mm, and bar diameter of 560mm. It was designed according to ACI 2005 standards to resist a torsional load of 12 kN-m and shear load of 66 kN. The calculations show that the designed longitudinal and shear reinforcement is adequate to resist the applied torsion and shear stresses.

Uploaded by

Bilal Al-Muhtaseb
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 3

PROJECT AL ERSAL DEVELOPEMENT DESIGN AGINST TORSION

DESIGNER AHMAD MUSTAFA ACI 2005


DATE
DETAIL DESIGNATION BPSD24 by Ahmad Alqaryoutee

* Parameters

B (mm) 240 ENTER (E) FOR EQUILIBRIUM OR (C) FOR COMPATIBILITY


H (mm) 600 c
d (mm) 560 Tu (Mpa) 12
COVER (mm) 40 LEFT SIDE 1.666159
SIDE COVER (mm) 40 RIGHT SIDE 3.423266
Tu (kN.m) 12 SECTION IS ADEQUATE
Vu (kN) 66
f'c (Mpa) 30 Vs (Mpa) -34.6899
FY (Mpa) 420 Av/S 0
Fyv (Mpa) 420 Tn (Mpa) 16
Ao (mm2) 65025
Acp (mm2) 144000 θ 45
Pcp (mm) 1680 COT θ 1
MAIN STEEL DIA (mm) 20 At/S 0.292927
OUTER STIRRUP DIA (mm) 10 A(v+t)/S 0.585854
Aoh (mm2) 76500 MINIMUM STIRRUPS A/S 0.195615
Ph (mm) 1320 A STIRRUPS /S 0.585854
Vc (Mpa) 122.68985 MAX SPACING (mm) 165
Tcr (Mpa) 16.901153
Tθ (Mpa) 4.2252883

Longitudinal Torsional Reinforcement


TORSION MUST BE CONSIDERED
Ø SHEAR & TORSION 0.75
SHEAR STRESS 0.9722222 Al CALCULATED (mm2) 386.665
MINIMUM Al (mm2) 395.7968
Al (mm2) 395.7968
0.095238

0.292927
-0.147491

You might also like