Scribd
Upload
47 views

Bluetooth Control Smart Car

This document describes a Bluetooth-controlled smart car that uses an HC-06 Bluetooth module to connect to Android devices or Bluetooth remotes. An ultrasonic sensor detects objects from 1-50cm and triggers different colored LEDs or a buzzer. A motor driver circuit controls the direction and movement of the car's motors. The required materials include an Arduino, batteries, motors, wheels, sensors, and other electronic components.

Uploaded by

Akhtar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
47 views

Bluetooth Control Smart Car

This document describes a Bluetooth-controlled smart car that uses an HC-06 Bluetooth module to connect to Android devices or Bluetooth remotes. An ultrasonic sensor detects objects from 1-50cm and triggers different colored LEDs or a buzzer. A motor driver circuit controls the direction and movement of the car's motors. The required materials include an Arduino, batteries, motors, wheels, sensors, and other electronic components.

Uploaded by

Akhtar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Bluetooth Control Smart Car

Working Principle:
This car can be controlled by any Bluetooth device such as android
mobile, Bluetooth remote, Bluetooth joystick. Connection is made
between the Bluetooth device and the car by a Bluetooth module named
HC-06.
When any object that is found in front of 31cm to 50cm of the car then a
Green LED is glow up, if the object that is found in front of 21cm to
30cm of the car then a Yellow LED is glow up and if the object that is
found in front of 1cm to 20cm of the car then a Red LED is glow up and
give buzzer. The object detection is made by an Ultrasonic Sensor
named HC-SR04.
The controlling of forward, revers, left and right of the motor as well as
the car made by a motor driver named L293D.

Required Apparatus:
i) Battery -3.7V 4 no’s
ii) ARDUINO UNO R3 1 no’s
iii) MOTOR Driver L298D 1 no’s
iv) ULTRASONIC SENSOR 1 no’s
v) LED-RED, LED-YELLOW, LED-GREEN
vi) Stitching Transistor 2N2222 1 no’s
vii) BUZZER 1 no’s
viii) DC gear MOTOR 4 no’s
ix) MOTOR wheel 4 no’s
x) Car chassis
xi) Connecting Wire
xii) BLUETOOTH Module HC-06 1 no’s
xiii) Project Board 1 no’s
xiv) Power Switch 1 no’s

You might also like