Technical Data Sheet
BOSS® 333 Polyurethane Expanding Foam
TYPICAL PROPERTIES
ASTM D-1622 Density 1.25 lbs./ft³
IN HOUSE METHOD Yield/24 Oz. Can 41.6 liters freely foamed
ASTM C-518 Thermal Conductivity 0.22 - 0.26 Btu-in/hr-F-ft²
ASTM C-518 R Value 3.8 - 4.5 hr-F-ft²/Btu
Tack Free (1” bead). 10 minutes (73°F & 50% RH)
Can Be Cut (1” bead) 90 minutes (73°F & 50% RH)
Fully Cured (1” bead). 24 hours (73°F & 50% RH)
ASTM E-84-04 UL 723 Fire Testing Flame Spread-10, Smoke Developed-30
DIN 53429 Water Absorption 1%
Service Temperature 40°F - 200°F
Application Temperature 40°F - 115°F
DESCRIPTION HOW TO USE
BOSS® 333 is a ready-to-use, multi-purpose, polyurethane foam Shake can before and during use. Surfaces must be clean and
that expands to three times its original volume on contact with free of grease and oil. Can must be held UPSIDE DOWN
air. The expanding action fills holes, cracks and gaps more during application. Insert straw into void and depress the trigger.
completely than standard caulks. BOSS® 333 has excellent Fill void 50% full to allow for expansion. For best results, use
insulating properties and superb adhesion to virtually all building in temperatures between 60°F to 90°F and spray mist into cavity
materials. prior to applying foam.
BENEFITS USES
• Meets CA-25-4 • Air sealing
• UL Classified, Tested to ASTM E-84 • Partition walls with ceilings
• Triple Expanding • Through penetrations around cables and pipes
• Weatherproofs against wind and moisture • Seams between chimneys, roof protection, roof panels and
• Fills gaps, cracks and holes wall panels
• Seals out insects and pests
• Can be sanded, painted and stained
• Complies with EPA Method 24 and California
Air Resource Board Method 310
• VOC Compliant
Page 1 from 2
Technical Data Sheet
SPECIFICATIONS STORAGE AND SHELF LIFE:
BOSS® 333 Polyurethane Expanding Foam meets CA-25-4, When stored in the original unopened containers at or below
complies with EPA Method 24 and California Air Resource Board 90°F (32°C), BOSS® 333 has a shelf life of 12 months from
date of shipment. In Countries where high and humidity are a
Method 310 and is UL Classified. factor, special precautions must be taken. Store product in a
covered, well-ventilated warehouse and avoid excessive heat
conditions. Storage in high heat, high humidity conditions may
PACKAGING reduce shelf life by up to 30%. Rotation of stock is an absolute
necessity. Cartons should always be stacked upright with the
BOSS® 333 Polyurethane Expanding Foam is available in nozzle tip pointed upwards. DO NOT stack cartons on their
12 oz. and 24 oz. cans. side. NEVER stack cartons more than 8 high. DO NOT store
within 1meter (4 feet) of roofline of the warehouse or storage
building.
CLEAN UP
Uncured sealant can be easily removed using BOSS® 335 USERS PLEASE READ
or a solvent such as alcohol or acetone. For an environmental
The information and data contained herein is believed to be
and health friendlier choice use BOSS® Biggie Wipes. accurate and reliable; however, it is the user's responsibility to
If the sealant is cured it must be removed mechanically by determine suitability of use. Since the supplier cannot know all
the uses, or the conditions of use to which these products may
cutting and scraping.
be exposed, no warranties concerning the fitness or suitability
for a particular use or purpose are made.
DANGER It is the user's responsibility to thoroughly test any proposed use
of our products and independently conclude satisfactory
EXTREMELY FLAMMABLE. CONTENTS UNDER PRESSURE.
performance in the application.
Turn off all pilot lights, electrical igniters, burners and other
sources of ignition or heat during use Do not smoke, use Likewise, if the application, product specifications or manner
matches or lighters while dispensing foam. Do not expose to in which our products are used requires government approval
direct sunlight, high heat or store in enclosed vehicle. Avoid or clearance, it is the sole responsibility of the user to obtain
breathing vapor/ spray. Use in adequately ventilated areas with sure authorization.
appropriate breathing apparatus. Avoid contact with skin and eyes.
Non-warranty: Because the storage, handling and application
Wearing eyewear and gloves is recom-mended. Do not incinerate
of the material is beyond Accumetric's control, we can accept
or puncture can. Store at temperatures below 120°F.
no liability for the results obtained. Accumetric's sole limited
warranty is the product meets the manufacturing specifications
EYE IRRITANT. May irritate or cause allergic reaction to skin.
in effect at time of shipment. There is no warranty of
Inhalation of vapor may result in respiratory allergies including
merchantability or fitness for use, nor any other express or
asthma. Persons with known isocyanate allergies should avoid any implied warranty. Accumetric will not be liable for incidental or
skin or respiratory contact with product ingredients. Use with consequential damages of any kind. The exclusive remedy for
adequate ventilation or suitable respiratory protective equipment. breach of such limited warranty is a refund of purchase price
Wear protective clothing to avoid skin contact. Wear eye protection. or replacement of any product shown to be other than as
warranted.
FIRST AID: Inhalation - move immediately to fresh air.
Eye contact - flush eyes immediately for 15 minutes. Suggestions of uses should not be taken as inducements to
Skin contact - wash affected area immediately with plenty of soap infringe any patents.
and water. Get medical assistance in all cases
(show label when possible).
SHIPPING LIMITATIONS
For further health and safety information consult the current Material Ground shipments only. Cannot ship by air.
Safety Data Sheet available from BOSS® Products at 800-928-2677. Reactive VOC 155 g/l (15% wt)
KEEP OUT OF REACH OF CHILDREN. CONTAINS:
Diphenylmethanedisocyanate, Polyol and Butane/Propane.
BOSS®
Accumetric Silicones Pvt Ltd
No 16/1, Corporation Road,
Seevaram, Perungudi.
Chennai - 600 096, India.
TEL +91 44 40260345 - 60
www.bossproducts.in
Page 2 from 2
