Scribd
Upload
286 views

CWT5010-5110 Installation Manual - en PDF

This document provides installation instructions for the CWT5010-5110 device in 3 sentences: It describes the hardware components of the device including the antenna connector, LED indicators, power switch, and SIM card slot. Details are given on connecting power, RS232, digital inputs, and relay outputs. Installation instructions are provided for inserting the SIM card and connecting the antenna.

Uploaded by

Victor Manuel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
286 views

CWT5010-5110 Installation Manual - en PDF

This document provides installation instructions for the CWT5010-5110 device in 3 sentences: It describes the hardware components of the device including the antenna connector, LED indicators, power switch, and SIM card slot. Details are given on connecting power, RS232, digital inputs, and relay outputs. Installation instructions are provided for inserting the SIM card and connecting the antenna.

Uploaded by

Victor Manuel
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

深圳市盈科互动科技有限公司 CWT CO.

, LIMITED
TEL：+86-755-26719954 ｜ www.mobq2000.com

Number Version Updated time


V2.0 2018-1

CWT5010-5110 Installation Manual

1 SIZE

Antenna connector

LED indicator

power switch

SIM card installation: push down the SIM card slot, then open the slot and insert the SIM
card into the slot，close the slot, and then insert the slot upward Push, stuck

1
深圳市盈科互动科技有限公司 CWT CO., LIMITED
TEL：+86-755-26719954 ｜ www.mobq2000.com

2 HARDWARE DESCRIPTION

2.1 DC power in
DC12-24V power in V+ and V-

2.2 LED indicator description

Indicator Status means


BAT On Interior battery is charging
(Green) Off Interior battery is fully charged
NET flashing quickly Registering network
(Red) Flashing slowly Network register successfully
flash every 600ms In setup mode
ACT flashes every 6 seconds Disarm status
(Yellow) Flashing 2 times
Arm status
every 3 seconds
1.When system start (power on)
On
SRV 2.While sending messages
(Orange) 1.System start complete
Off
2.Sending message complete

2.3 Antenna
Standard SMA female interface (50Ω)

2.4 Wiring terminal

4 3 2 1

Terminal specification: 14pin * 3.81mm

① DC12-24V (Power in or out)


DC12-24V power in V+ and V-

the output voltage is equal to the RTU power supply voltage.

② RS232
wiring diagram

2
深圳市盈科互动科技有限公司 CWT CO., LIMITED
TEL：+86-755-26719954 ｜ www.mobq2000.com

③ 4 Digital Input

Accept dry contact

④ 4 Relay Drivable Output


Type: transistor output
Output drive voltage=power supply DC voltage, drive current ≤500mA
Exterior relay connection:

3
深圳市盈科互动科技有限公司 CWT CO., LIMITED
TEL：+86-755-26719954 ｜ www.mobq2000.com

Relay Coil-

Relay Relay

Relay Coil+

You might also like